User's Manual

11
When you choose Indoor ceiling omni antenna or whip antenna, the best place to
install it is the center of your house as the graph shows.
3. Install the signal booster
Step1: Select an indoor location near to a power outlet on a wall.
Step2: Mount the booster with the screws included as shown in the figure.
Step3: Connect the outdoor antenna cables to booster connector marked
“outdoor”. Tighten the connection with hand or wrench.
Step4: Connect the indoor antenna cables to booster connector marked “indoor”.
Tighten the connection with hand or wrench.
Step5: Connect the AC power cord to the signal booster, and then connect the
plug to the electrical outlet to power on the booster
Booster installation Connection from cable to booster
4. Booster Commissioning
Overview: The booster has quite intelligent startup system, booster commissioning
is an automatic process to guarantee its optimal performance.
After finishing the booster system installation, please power on the booster, the
booster starts its initialization to check it is receiving signal, the isolation status to
ensure its best performance. This will take around 3~5 seconds.
After the booster start up, please check whether the coverage is good. If it is good,