User's Manual Part 1
11
©2015 Hubsan
ֻӰ೨ሙNjྠిద
CAMERA
Method: 1. Unscrew the fix set for camera, remove the fix set.
2. Put the camera on the slot(camera facing outside), install the fix set, fix it with screws.
3. Plug the camera data wire into the USB interface, plug the other end into the X4 Pro
external interface（see more details on 2.3.1）.
2.2.5 INSTALL THE CAMERA
EXTERNAL INTERFACE
3.2.4 CAMERA LIGHTS
ƔPower on the camera to copy from the SD card. The camera is only charging when the
power is off and it is connected to the PC. The camera cannot record video when it is
connected to a PC.
ƔWhen you remove the camera USB connector from the camera when it is taking video,
the camera will continue taking video. If not taking video the camera will automatically
power off if USB connector disconnected from the camera.
ƔThe camera will be charging when connected to the X4 Pro or the PC, charging circuit
is about 500mAh, the camera battery is 3.7V/ 670mAh.
Camera LIGHT Camera condition
Blue light turns on Standby
Blue light turns on, red light blinks once every
second
Recording
Camera module is faulty
Blue light turns on, red light turns on
Blue light blinks every second
Micro-SD card will be full/ no SD card/ faulty SD card
Blue light blinks quickly
Red light blinks quickly
Micro-SD card is full
Battery power is low
Use a Micro-USB connect to the PC. Power on the camera to copy the pictures/videos from the
camera and charge the camera at the same time.