User's Manual

7Insert the battery into the compartment
8Connect the plugs
9Lay the canopy, aim into the buckles
10Put on the body stickers
The parameters of the stabilization system are factory preset, no need for initialization.
Question 6: The LCD screen is not viewable outdoors with bright sunshine.
Answer:
Check the packaging inside the box, there is an anti-glare sticker, it will help you to reduce glare in
full sunshine. Peel the protective membrane and put it onto the screen.
Question 7: The battery life is too short and the battery will not charge.
Answer:
The Lipo battery has a protective voltage safety board with a cut o function. Once the Lipo battery’s
individual cell voltage drops below 3 volts, you will need to use an intelligent charger to revive the
battery.
Question 8: The video is not being saved to the SD card.
Answer:
Always stop the video recording function and power o the battery rst. After that you can take out
the SD card.
Always turn o the power to the Air Plane before inserting or removing the SD card.This allows the
memory to be properly saved to the SD card.
Question 9: I can not launch the airplane.
Answer:
The direction and strength of the wind will have a great eect on the ight performance of your
model. Launch and release your airplane against the wind with its nose pointing slightly above the
horizon. The wind speed should be not more than 3M/S.
Question 10 : The servos are getting too hot with noise.
Answer:
Check all connections on the pushrods, servo arm and servo horn for smooth operation and adjust
the connections as required.Adjust the servo travel on each channel, or reduce the sensitivity on
each channel in the transmitter settings.
Question 11: It is not arming after binding.
Answer:
Minimize the throttle to zero, or adjust the throttle trim to zero.
Question 12: The airplane out of control during ight
Answer:
11Open the camera cap before recording 12The camera cap can hang on the
Transmitter's handle
18
SPY HAWK
H301S
05
SPY HAWK
H301S
www.hubsan.comwww.hubsan.com