User's Manual

5.5 Basic Flight

The operations of the controller are based on Mode 2.

The left stick controls the altitude and rudder of quadcopter, and the right stick controls

its forward, backward, left and right flight.

Transmitter (Mode 2)

X4 Remarks

The throttle stick controls the ascent and

descent .

Push up the stick and the X4 will ascend.

Pull down the stick and the X4 will descend.

When the stick is in the center, the X4 will hover

and hold its alititude automatically .

Move the throttle stick above the center position

to take off. (Move the stick gradually to prevent

the X4 from ascending too quickly.)

Down

The Rudder stick controls the rotate direction

Push the stick to the left and the X4 will rotate

counter-clockwise

Push the stick to the right and the X4 will rotate

clockwise.

When the stick is in the center,the X4 will keep

the current direction and not rotate.

Pushing harder will cause the X4 to rotate

faster in the corresponding directions.

Right rotation

Left rotation

5.4 ARM/ DISARM THE MOTORS

Arm the motors

Method : Pull both sticks to the lower outer corner as shown

on the picture to arm the motors. Release both sticks

after the motors are armed.

If the motors can not be armed after binding, please make sure:

1. Compass calibration is completed

2. The value of Fly When No GPS is “YES”

3. GPS switch and RTH switch is OFF.

Disarm the motors

Method : Pull both sticks to the lower outer corner again to arm the motors, and release both sticks

after the motors are disarmed.

Do not stop the motors during the flight to avoid crashing.

Push the sticks lightly. Release the sticks after the motors are armed or disarmed.