Operating Instructions


Warning beep icon: It shows up when the warning beep button is pressed. Ten
levels of beep sound (00 is the invalid state) are selectable by pressing the “+” and “-” buttons.
Level digital display icon: It shows up when the level of vibration or beep sound
is adjusted.
Operating instructions for the transmitter: Without a power button, the unit
starts when any key is pressed and enters the sleep mode (power-off) automatically when there is
no operation for five seconds.
1. Channel selection button: The transmitter has three channels available for choice. One
transmitter can control up to three receivers, which can be achieved by adjusting the three pet
receivers to three different channels. In case of such a need, you shall select and purchase the
three-receiver combination package. To switch to the next channel, you shall press and hold
down the channel selection button for three seconds, and so on. For the first time of use, you
shall check whether the receiver corresponds to the selected channel of the transmitter, with CH1
corresponding to the red light of the receiver, CH2 corresponding to the green light of the
receiver, and CH3 corresponding to the blue right of the receiver. Such one-to-one
correspondence is a precondition for the remote control of the unit. When power-off or in a sleep
mode, the channel setting will be retained automatically so that no adjustment is needed for the
next use.
2. Call button: This button can be used when the pet has run too far away to see or merely
when you cannot find it. To use the button, you shall make sure that the receiver agrees with the
selected channel and is power-on first. Then, you can hold down the call button and speak into the
microphone, and the receiver will hear the voice command synchronously. (Such a function can
bring a better interactive experience between you and the pet. It can make the pet execute your
voice commands or recall the pet even when you cannot see it. When used together with the beep
sound or the vibration mode, it will present an even better effect.) The transmitter allows you to
talk to your pet up to 1500 meters when used in open and unobstructed areas and as far as 50 to
500 meters (the sound volume of the receiver is not adjustable) even when there are obstacles or
walls. If you release the call button, the call will be finished. Where two or three receivers are used
at the same time, you will have to switch to the corresponding channels before sending different
commands. Remember this!
3. Warning beep button: The level of the warning beep can be set as 0-10 by the “+” and “-”
buttons, among which level 0 is the static mode, which can prevent the warning beep from being
triggered accidentally, level 1 is the minimum level, and level 10 is the maximum level. When the
button is pressed once, the receiver will make a beep sound once. If the button is pressed and held
down all the time, the receiver will keep beeping.
4. Vibration button: The level of vibration frequency can be set as 0-10 by the “+” and “-”
buttons, among which level 0 is the static mode, which can prevent the vibration from being
triggered accidentally, level 1 is the minimum level, and level 10 is the maximum level. When the
button is pressed once, the receiver will vibrate once. If the button is pressed and held down all the