Installation Instructions

FCC Statement
This device complies with Part 15oftheFCC rules.
Operation is subject to the following two conditions：1)
This device may not cause harmful interference， and 2)
this device must accept any interference received，
including interference that may cause undesired operation.
Reorient the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into and outlet on a circuit different from
that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
Changes or modifications not expressly approved by the party
responsible for compliance could void your authority to operate
the equipment.
The distance between user and products should
be no less than 20cm.
The EUT is Indoor use only
This equipment has been tested and found to comply with
the limits for a Class B digital device， pursuant to Part 15 of
the FCC rules. These limits are designed to provide reasonable
protection against harmful interference in a residential
installation. This equipment generates， uses and can radiate
radio frequency energy and if not installed and used in
accordance with the installation, may cause harmful interference
to radio communications. However,there is no guarantee that
interference will not occur in a praticular installation.
If this equipment does cause harmful interference to radio or
television reception， which can be determined by turning the
equipment off and on， the user is encouraged to try correct
the interference by one or more of the following measures：