Installation Guide

Smart Host Pro

MODEL：H201-ST-SH00

Directory：

1. Product introduction

2. Product list

3. Installation guide

4. Configure wi-fi

5. Product parameters

6. Matters needing attention

7. Technical support

一、product introduction

ZigBee HA wireless communication protocol is adopted, equipped with the global

universal channel 2.4ghz, to achieve 10ms quick response.Crystal glass material,

with 3.5-inch IPS display.Independent and distributed compatible multi-attribute

intelligent host, one APP client can correspond to multiple intelligent hosts.

二、Product list

Before using this product, please check whether the goods in the package are

complete, if there is a lack, please contact the after-sales center.

1 x products

1X product manual

1X product warranty card

1 x certificate

2 x screw

三、Installation guide (drawing sketch)

1. This product is divided into two parts: a. B. Screw plate.

2. Fix the screw plate b on the type 86 universal bottom box with 2 screws.

3. Correctly connect the power line and network line according to the wiring

marking of the bottom box of the host.Note: make sure the power is off

4, install the main body a into the screw plate b, that is, the installation is

completed.

四、Configure Wi-Fi

1. Click " " to enter the setting interface.

2. Click "WiFi" to select the corresponding network, and then enter the wi-fi

password, and the network will be successfully configured instantly.

五、product parameters

Product size: 96*86*35 (mm)

Power supply: AC 100 ~ 240v power supply 50/60hz

Communication protocol: ZigBee HA

Wireless standard: IEEE 802.15.4 (2.4ghz)

Communication rate: 250Kbps

PAGE 1
Smart Host Pro MODEL：H201-ST-SH00 Directory： 1. Product introduction 2. Product list 3. Installation guide 4. Configure wi-fi 5. Product parameters 6. Matters needing attention 7. Technical support 一、product introduction ZigBee HA wireless communication protocol is adopted, equipped with the global universal channel 2.4ghz, to achieve 10ms quick response.Crystal glass material, with 3.5-inch IPS display.
PAGE 2
Standby power: 3W Working humidity: 5~85% no condensation Working temperature: - 10 ℃, 50 ℃ Transmission distance: 100M (open environment) Connection mode: zero - wire 六、Matters needing attention 1、Before installation, the product should be stored in a dustproof, moisture-proof and mildew-proof environment. 2. Slight fever occurs during the use of this product, which is a normal phenomenon. 3.
PAGE 3
FCC STATEMENT : This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation. Warning: Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.