User's Manual

20
Operation: Press the Squelch Off key to enter this mode, and press it again to exit.
z Squelch Off Momentary
Purpose: Refer to Squelch Off.
Operation: Hold down the Squelch Off Momentary key continuously to enter this mode,
and release the key to exit.
z Monitor
Purpose: In this mode, the receiving party can receive incoming calls from the transmitting
party regardless of CTCSS/CDCSS condition. If the carrier condition is not satisfied, the
receiving party will fail to receive any incoming calls.
Operation: Press the Monitor key to enter this mode, and press it again to exit.
z Monitor Momentary
Purpose: Refer to Monitor.
Operation: Hold down the Monitor Momentary key continuously to enter this mode, and
release the key to exit.
Scan
The Scan feature enables a two-way radio to continuously scan each channel for activity.
Press the key programmed as Scan, scan starts from the current channel and ascends
through the channel numbers in scan list. The Status Indicator flashes green during
scanning. When signals are received on a certain channel with signaling matches, the
Status Indicator solidly glows green. To exit Scan mode, press this key again.
When Scan feature is activated, the radio begins continuous scanning for activity on
channel that can be scanned. If any activity is detected, the radio will switch the channel to
receive the call (the channel that can be scanned are programmed by your dealer).
No Priority Channel
Suppose there is a scan list of 6 channels and all channels are non-prioritized, the normal
scan operation may proceed in the following sequence, as shown in Figure 1.