User's Manual

32
1. Key press
When radio standby, press the Scan key on a channel assigned with a Scan List, to start
scan.
2. Auto
If Auto Scan is enabled for a channel assigned with a Scan List, the radio shall
automatically initiate scanning when it switches to the channel.
3. Menu selection
 Scan Exit
The radio emits a programmable alert when it exits scanning, with the
icon
extinguished.
Exit scanning by the following methods:
1. Press the Scan key during scan process.
2. When the radio switches to a channel where a Scan List is not set, or a channel
where the Auto Scan is disabled, the radio shall exit Scan Mode.
3. Menu selection
4. Press the Call key to encode.
5. Press the PTT to encode, except for PTT ID.
6. Receive the Stun code.
7. Activate the Emergency feature.
8. Turn the radio off.
 Scan Pause
Entering the main menu while in Scan Mode, shall cause the radio to pause scanning. The
radio shall resume scanning when it exits the main menu.
 Hang Scan
If a match signal is detected on a Scan List member, or press the PTT or Monitor key, the
radio shall wait on the channel. The radio displays ”
P•” if it waits on the Priority Channel 1,
or “
P:” if it waits on the Priority Channel 2.