User's Manual

TC－1600 Owner’s Manual

In factory default setting, the communication range alarm is disabled.

a. Enable Communication Range Alarm b. Disable Communication Range Alarm

Figure16: Set Communication Range Alarm

PC Programming Mode

In standby mode, connect the radio and a PC with programming cable and then

programme the radio through programming software, the radio enters PC programming

mode. LCD display is shown as figure17. During programming, the black cursor in the

center of LCD will scroll. When programming is complete, the character “P” will be

displayed on the center of LCD. In the PC programming mode, the radio communicate

with PC through UART port, all the commands are carried out via PC. After programming,

the radio should be turned off and back on again to use.

a. Programming b. Programming Over

Fig17 PC Programming Mode

Wired Clone Mode

Connect the radio with cloning cable and then turn the power on while holding down CALL

and MON key simultaneously. After 2 seconds, the radio enters wired clone mode (source

side).

When the radio enters wired clone mode, LCD display is shown as figure18. The black

cursor in the center of LCD flashes. When the target radio is ready, press MON key to

begin cloning. The black cursor in the center of LCD will scroll. During cloning, if an error

occurs or the target radio has no response, the cloning stops and LCD displays error

prompt. “F” (FAIL) indicates that wired clone is failed. If data is cloned successfully, “P”

(PASS) appears.

Blink

Scroll