THANK YOU! We are grateful for your purchase of HYT product. We believe this easy–to-use radio will provide you with dependable and reliable communications. This HYT portable two-way radio is a precision device. Treat it with care, and you will enjoy years of reliable operation.
Contents User Safety, Training, and General Information Compliance with RF Energy Exposure Standards FCC Compliance Precautions Product Inspection Battery Information Accessory Installation Battery Antenna Belt Clip Earplug Cover External Earphone/Microphone (optional) Getting Started Features and Operation Turn on/off the radio Adjust the Volume Select Channel Transmit Receive Monitor Repeater/Talk Around Repeater/ Reverse Frequency Selectable Power Scan Call Selective Call Emergency Siren VOX Feature Bui
User Safety, Training, and General Information READ THIS IMPORTANT INFORMATION ON SAFE AND EFFICIENT OPERATION BEFORE USING YOUR HYT PORTABLE TWO-WAY RADIO. Compliance with RF Energy Exposure Standards Your HYT two-way radio is designed and tested to comply with a number of national and international standards and guidelines (listed below) regarding human exposure to radio frequency electromagnetic energy.
Use only HYT approved, supplied batteries or HYT approved replacement batteries. Use of non- HYT -approved batteries may exceed FCC RF exposure guidelines. Approved Accessories For a list of HYT approved accessories, see the accessories page of this user manual or visit the following website which lists approved accessories: http://www.HYT.com.cn FCC Compliance This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules.
Product Inspection Thank you for your use of HYT portable two-way radio TC3000. Before use, you are recommended to inspect the product as follows. First check the shipping carton for any signs of damage. If any damage has occurred, please contact your dealer immediately. Confirm the supplied product against the packing slip to assure accuracy. Available Accessories Item Qty.
will be shortened. Store the battery in a place about 25℃. Charging the battery in less than 10℃ temperature will cause the electrolyte leakage and damage the battery. Charging the battery in over 35℃ temperature will affect the battery capacity. Charging the Battery You are recommended to use HYT authorized charger. Charger LED will indicate the charging status.
Battery Latch Fig.2 Antenna Insert the threaded end of the antenna into the connector on top of the radio. Rotate the antenna clockwise to fasten it. Rotate the antenna counterclockwise to remove it. (See the following figure) Install Remove Belt Clip Attach Belt Clip Align the slot of the belt clip with the T-slot at the battery cover and press the belt clip downwards until it is locked.
Fig.3 Remove the belt clip Press the disassembly release upwards with a key until it releases and then push the belt clip upwards with your thumb to remove it. (See figure 4) Disassembly 拆卸擎 Release Fig.4 Earplug Cover Rotate the screw at the bottom of the cover counter clockwise by a screwdriver until it is out of the nut to remove the Earphone/Microphone jack cover.
Fig.5 External Earphone/Microphone (Optional) Insert the tab at the bottom of the earphone/microphone into the slot on top of the radio. (See figure 6). Align the nuts at top of the earphone/microphone with the holes on the radio and then turn them clockwise to fasten. Fig.
Getting Started (1) Antenna Used to transmit/receive signals. (2) LED Following table indicates LED indication and corresponding radio status. LED No display Status Standby Green Receive Red Transmit Flashing green Scan Flashing red Low battery voltage Flashing orange Call waiting (3) Channel Selector Used to select wanted channel.
Used to connect with external earphone or programming cable. (10) Belt Clip Used to clip the radio on your belt. (11) Battery Pack (12) PTT key Press and hold PTT, radio operates in transmit mode. Release PTT, radio returns to receive mode. (13) Programmable Key [B] (14) Programmable Key [C] The following table shows the key function when 1. Briefly press; 2. Press and hold (more than one second); 3. Hold down and monitor.
Features and Operation Note: TC3000 provides a series of audible alert tones.
4. Then you can receive a valid call. LED glows green during receiving. 5. If CTCSS/CDCSS or squelch tail elimination feature is set by your dealer: 1) Noise will be removed by the end of a conversation if roger tone is disabled. 2) Beep tone sounds by the end of a conversation if roger tone is enabled; Please contact your dealer for more details. Monitor 1. Press MONI key to monitor the current channel. 2. Release MONI key to exit.
Nuisance Delete Nuisance delete feature allows you to temporarily delete an unwanted channel from the scan list. When the radio stops on the nuisance channel, press the programmed “nuisance delete” key until an alert tone is sounded to delete this channel. When scan feature is enabled again. The deleted channel will return to the scan list. Note: Priority channel can’t be deleted. Priority Channel Scan This feature allows you to scan important channels.
enabled, the radio will sound continuously at highest volume. 1. Press Emergency Siren key to activate Emergency Siren feature. 2. Press and hold Emergency Siren key to disable Emergency Siren feature. 3. Press Emergency Siren key again to activate Emergency Siren feature. VOX Feature Plug an earphone with VOX feature into the radio to enable VOX feature. 1. VOX feature enables you to transmit automatically by speaking into the microphone. 2. Transmission stops automatically when you stop speaking. 3.
Care and Cleaning Do not carry your radio by the antenna or remote microphone; Wipe the battery with a lint-free cloth to remove dirt, grease, or other material that may prevent good electrical connection; When not in use, keep the accessory jacks covered with the protective caps; Clean the shell, controls and keys of your radio with neutral detergent and warm water after a long period of usage. Avoid using strong chemicals.
Frequency Chart Model: Serial Number: Chan nel Transmit Frequency Transmit CTCSS Transmit CDCSS Transmit 2-Tone Transmit 5-Tone Transmit ANI DTMF Receive Frequency Receive CTCSS Receive CDCSS Receive 2-Tone Receive 5-Tone 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17
HYT endeavor to achieve the accuracy and completeness of this manual, but cannot guarantee its accuracy at all times. All the above specifications and design are subject to change by HYT without notice. All the reproduction and translation of this manual without authorization of HYT is not allowed.
