User's Manual

4. Then you can receive a valid call. LED glows green during receiving.

5. If CTCSS/CDCSS or squelch tail elimination feature is set by your dealer:

1) Noise will be removed by the end of a conversation if roger tone is disabled.

2) Beep tone sounds by the end of a conversation if roger tone is enabled;

Please contact your dealer for more details.

Monitor

1. Press MONI key to monitor the current channel.

2. Release MONI key to exit.

Repeater/Talk Around

When the repeater doesn’t work or you are out of the communication range of the

repeater and within the communication range of your group member, you can bypass

the repeater and talk directly to your group member.

Press programmed “Repeater/Talk Around” key to select between repeater and talk

around mode. An alert tone indicates that radio operates in talk around mode. A different

alert tone indicates that you are talking via a repeater.

Repeater/Reverse Frequency

When you are out of the communication range of the repeater and within the

communication range of your group member, you can talk with your group member by

reverse frequency if your group member is within the communication range of the

repeater.

Press programmed “Repeater/Reverse Frequency” key to select between repeater and

reverse frequency. An alert tone indicates that radio operates in reverse frequency mode.

A different alert tone indicates that you are talking via a repeater.

Note: “Repeater/Talk Around” and “Repeater/Reverse Frequency” can’t be set

simultaneously in one radio.

Selectable Power

Each channel of the radio is set as different power levels that are user selectable. (High

power is forbidden in certain channels).

1. High power allows your talk to be heard from further distance.

2. Low power helps to save battery power.

Press programmed “power select” key to select high/low power. An alert tone indicates

that the radio operates at high power and another alert tone indicates low power.

Scan

Scan feature allows you to monitor all channels.

When scan feature is enabled, the radio will detect all channels. If an active channel is

detected, the radio will remain on that channel and you will be able to hear the

conversation.

Disable/Enable Scan Feature

1. Press scan key, scanning begins.

2. Press scan key again, scanning ends.

LED flashes green in scan mode.

Callback

Pressing PTT during scanning can callback on the callback channel. Please contact

your dealer for more details about callback channel.