User's Manual

JW1582,JW1583 User manual
3. When the alarm sounds you may:
a. SNOOZE: Press the SNOOZE button (Fig.1) your sleep time will be
extended by 9 minutes .You may use this feature until you turn the
alarm off.
b. RESET: Turn the alarm off by pressing ANY on the unit, except for
the SNOOZE button (Fig.4). The alarm clock will automatically reset
for the next day in its current mode. The ALARM BELL icons and
outline border will remain displayed to indicate the alarm is set. If you
wish to change the wake mode follow step 2 under Setting and Using
Alarm 1 and Alarm 2 Together.
c. OFF: To completely turn off the alarm so it is set for the next day, slide
the alarm switch to OFF.
Note: If one of the Alarm users still needs their alarm set, you will need to
slide the switch on the back of the unit to the alarm corresponds to their
wake time.
Note: If the alarm sound for 30 minutes continuously it wall automatically
turn off.
Using the Projection Feature
1. To turn the projection feature on, slide the ON/OFF switch (Fig 3) on the
back of the unit to the ON position. The time & outdoor temperature is now
projected on the wall or ceiling.
Note: If he projection feature is OFF, you may hit the SNOOZE button
(Fig.1) to trigger 15 seconds of projection.
2. The angle of the projection can be adjusted to angle on the ceiling or wall
by moving the PROJECTOR TUBE (Fig.3) forward or backward.
Using Indoor Temperature
The unit will begin reading indoor temperature when it is plugged in. Allow a
few minutes for the correct temperature to register on the LCD display. (Fig.2)
JW1582,JW1583 User manual
Using outdoor Temperature
Be sure the Sound Spa unit is plugged in prior to the remote sensor battery
installation.
Remote Sensor Battery Installation:
1. Loosen the 4 screws securing the battery cover with a small screwdriver
(included) and remove. Insert 2 alkaline AAA batteries according to the
polarity direction indicated.
2. Place the home receiver (Sound Spa Premier) as close as possible to the
remote sensor. This will help with synchronization between the two units.
Note: Once you are ready to position you remote sensor and home
receiver, ensure that the distance is not outside the effective
transmission range (100 feet). Some building materials and location of
the home receiver or remote sensor can affect transmission quality and
range. Try various for best results.
3. Press the C/F button inside the remote sensor to change between ℃ and
℉. (The remote sensor is preset on℉)
4. Press the TX button inside of the remote sensor to verify the reception.
1. Replace the cover and tighten the 4screws.
Note: It is recommended to test the units next to each other to ensure
that both the remote sensor and home receiver are properly
synchronized.