User Manual

Shenzhen JBT Smart Lighting Co.,LTD

2. Bluetooth manual add:

Power on the device and quickly open the APP to add a device interface Manually add a

Bluetooth device Click to search to find the device network connection

3. EZ distribution network:

The device is powered on and flashes quickly to open the APP add device interface to manually

add a WIFI device, EZ mode distribution network connection

4. AP distribution network:

Power on the device. Press and hold the power button for 5 seconds, and the indicator light will

flash slowly. Open the APP add device interface to manually add a WIFI device, EZ mode, click

slow flash (once every 2 seconds) to connect to the network.

FCC Statement

This equipment has been tested and found to comply with the limits for a Class B digital device,

pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable

protection against harmful interference in a residential installation. This equipment generates,

uses and can radiate radio frequency energy and, if not installed and used in accordance with

the instructions, may cause harmful interference to radio communications. However, there is

no guarantee that interference will not occur in a particular installation. If this equipment does

cause harmful interference to radio or television reception, which can be determined by

turning the equipment off and on, the user is encouraged to try to correct the interference by

one or more of the following measures:

•

Reorient or relocate the receivingantenna.

• Increase the separation between the equipment and receiver.

•

Connect the equipment into an outlet on a circuit different from that to which the receiver is

connected.

• Consult the dealer or an experienced radio/TV technician for help.

Caution: Any changes or modiﬁcations to this device not explicitly approved by manufacturer

could void your authority to operate this equipment.

This device complies with part 15 of the FCC Rules. Operation is subject to the following two

conditions: (1) This device may not cause harmful interference, and (2) this device must accept

any interference received, including interference that may cause undesired operation.

RF Exposure Information

This equipment complies with FCC radiation exposure limits set forth for an uncontrolled

environment. This equipment should be installed and operated with minimum distance 20cm

between the radiator and your body.