User's Manual Part 2

3029
5. Booting
· If this item is set as Enabled, the system can be started within five
seconds and some detection items will be ignored. The options are
[Disabled] and [Enabled].
· Quiet Boot
To start the system quietly.
· Add On ROM Display Mode [Force BIOS]
This item allows you to set the display mode of the device's firmware
program. The options are [Force BIOS] and [Keep Current].
· Bootup Num-Lock
(To set the state of Num Lock after start-up). Options are OFF and ON.
Quick Boot
Fig 3.8
In other words, this item can be used for setting the state of Num Lock
for the time the system has been started. It can be set on the basis of
the needs of the user and doesn't affect the performance of the computer.
· PS2 Mouse Support
Set to support PS2 mouse. The available options are [Auto] and
[Disable]. The default value is Auto.
· Wait For“F1” If any Error
(The system waits the user to press F1 if any error occurs from the
computer). The options are Disable and Enable. Normally, it is set as
Enable. Then if the computer has any error, a line of English words will
appear on the screen, reminding the user of pressing F1 to enter CMOS
for setup. If it is set as Disable, that line of English words won't appear.
However, if the words “wait…” appear during the start up process and
you press Del, the system can also enter CMOS for setup.
· Hit “Del” Message Display
(Information is displayed when the computer is started, suggesting the
user can press “Del” to enter the state for CMOS setup). The options
are [Disable] and [Enable]. Normally, [Enable] is selected. After
[Enable] is selected, the information on how to enter the state for
CMOS setup will be displayed at the time the computer is started. If
[Disable] is selected, such information won't be displayed. However,
if you press “Del” when the character “Wait……” appears at the time the
computer is started, the system can also enter the state for CMOS setup.
· Interrupt 19 Capture [Disabled]
If you use some PCI extension cards with built-in firmware program
(like SCSI extension card) and you want to start the system through
Interrupt 19, you can set this item as [Enabled]. The options are
[Disabled] and [Enabled].