User's Manual

ManualsBrandsShenzhen Jehe Technology Development ManualsElectronicsMini PC

1716

2. Maintenance

As a high-tech product with sophisticated structure, Giada Mini PCs needs to be

maintained with properly. Misuse or rough handling may result in damage or

system failure.

Caution: Risk of explosion if battery is replaced by an incorrect type. Dispose of

used batteries according to the instructions.

· Body

Please prevent sharp objects from scratching on it. Make sure the power

supply to the host is cut off before cleaning the body. Never use wet cloth for

cleaning. Otherwise, water drops or other conductive liquid may go into the

host.To clean the base of the host, you should first remove the host. At the

time, you should put the host in a safe place where is won’t slide down or fall

onto the ground.

· Handling

This product is an ultra-light PC

Never place the product at the edge of the table. Otherwise, it may fall on the

ground and be damaged.

Always check the peripheral equipment and the connection cables to see

whether they are properly arranged, so that people might not be stumbled by

the wire or equipment and equipment not damaged.

· Radiation

Radiation is of great significance for PCs. Please place the product in a proper

position. Never block the air inlet and air outlet that are used for ventilation.

Do not place the product onto the bed, sofa or other soft objects for use.

Otherwise, the vents might be blocked and system halted because of the

overheating.

· Interfaces

Never use other objects to jam the interfaces on the host, nor use sharp

objects to scratch the pins. Otherwise, the pins might be damaged. If there is

any poor contact, you can use a soft brush to dust the place.

VI. Troubleshooting

Giada Mini PC was designed with the latest technologies and strictly tested before

delivery. It can provide long continuous working period and few failures might occur.

You may encounter some simple problems on setup, operation or system

compatibility at times you use the product. In this part, we will present the information

on how to identify the cause of a failure and how to solve the problems.

Identification: When your PC has a problem, please check it by referring the

information provided below:

1. PC has no reaction after the host is powered on.Make sure the power is supplied

to the host and the monitor, and check the power supply is normal running state.

If the hardware has been upgraded, make sure the new hardware was properly

and reliably installed. Check whether all signal cables are properly connected,

including cables between the keyboard and host, and mouse and host.

2. Host is automatically shut off. Please check whether the power supply is cut off,

or the power adapter is firmly inserted.

3. After the host is started, the start-up information appears. However, the operating

system can’t be loaded. The start-up order of setup tools is not compatible with

the configuration of the PC, or a password is set for your operating system. In

the latter case, you should enter the password to load the operating system.

4. Speaker sounds when the system is being electrified. Check whether there is

any part inside the host, especially whether the hard disk and memory are

properly installed. Note: The shell of the host should be opened only with the

assistance of professionals from Giada.

5. When the system is started, it seems the set parameters of the host have been