User's Manual

TELEPHONE SETUP
BATTERY INSTALLATION
13
14
Tone Pulse SwitchTo n e Pulse Switch
V01
GP60AAAH3BMX
GPI INTERNATIONAL LTD.
NS-NI-MH BATTERY
ZHONGSHAN NEWSTAR BATT.CO.
B
R
Tone/Pulse Switch
1. Choose the correct dialing mode.
2. Select the dialing mode Tone or Pulse by
setting the switch at the back of the base
unit.
Note: Changes to the switch position during a
call do not take effect until the call has
ended.
Note: If you are unsure of the proper dialing mode, make a trial call with the dial
mode setting to TONE. If the call connects, leave the switch as is(TONE
mode), otherwise, set to PULSE.
To install the 3.6V 600mAh cordless handset battery pack:
1. Slide open the battery compartment door on the back of the handset.
2. Plug the battery connector into the 2-pin connector in
the battery compartment and then insert the battery.
3. Close the battery compartment door.
4. Place the handset on the base unit cradle.
5. Once you have installed the battery pack and placed
The handset on the base you will hear a tone indicating
The handset has connected with the base and will
successfully charge.
6. Charge the battery pack for at least 12
hours before using the handset the first time.
7. The LED on the base illuminates when the
handset is properly making contact with the charge
terminals.
A fully charged battery lasts for approximately:
5 hours when you use the handset continuously (talk
time).
5 days when the handset is not in use (standby).
The display will show
IMPORTANT:
CHARGE
Battery Duration
When the Battery Needs Charging
LOW BATTERY ..
T/P
TEL
-
+
POWER SOURCE 9VDC 300mA
USE ONLY WITH CLASS 2