User's Manual
Table Of Contents
- 1. Product Overview
- 2. Pin definition
- 3. Electrical parameters
- 4. Reflow welding temperature curve
- 5. Application circuit
- 6. Contact Us
- Federal Communication Commission Statement (FCC, U
- FCC Caution:
- IMPORTANT NOTES
- OEM integration instructions:
- Validity of using the module certification:
- End product labeling:
- Information that must be placed in the end user ma
- Integration instructions for host product manufact
- 7.2 List of applicable FCC rules
- 7.3 Specific operational use conditions
- WiFi Specification：
- BLE Specification：
- 7.4 Limited module procedures
- 7.5 Trace antenna designs
- 7.6 RF exposure considerations
- 7.7 Antennas
- 7.9 Information on test modes and additional testi
- 7.10 Additional testing, Part 15 Subpart B disclai
BL-61C WIFI+BLE module
Copyright © 2020 ShenzhenJiXinInteligence Co., Ltd All Rights Reserved
Page
11
of 19
33
NC
reserved pin
34
RX
GPIO7; UART0_RX; I2C_SDA; PWM_CH2;(Only this UART0
can be used to burn firmware)
35
TX
GPIO16; I2C_SCL; UART0_TX; PWM_CH1; (Only this
UART0 can be used to burn firmware)
36
NC
reserved pin
37
NC
reserved pin
38
GND
ground
3. Electrical parameters
3.1 Electrical characteristics
parameter
test condition
min
Typ.
max
unit
Storage Temp.
-
-45
normal
135
℃
Work temp.
-
-30
20
85
℃
Max welding
temp.
IPC/JEDEC J-STD-020
-
-
260
℃
Static Protection
（HBM）
2000
V
Supply volt.
VCC
3.0
3.3
3.6
V
I/O
V
IL
VCC_IO=3.3V
-0.3
-
1.32
V