User's Manual
Table Of Contents
- 1. Product Overview
- 2. Pin definition
- 3. Electrical parameters
- 4. Reflow welding temperature curve
- 5. Application circuit
- 6. Contact Us
- Federal Communication Commission Statement (FCC, U
- FCC Caution:
- IMPORTANT NOTES
- OEM integration instructions:
- Validity of using the module certification:
- End product labeling:
- Information that must be placed in the end user ma
- Integration instructions for host product manufact
- 7.2 List of applicable FCC rules
- 7.3 Specific operational use conditions
- WiFi Specification：
- BLE Specification：
- 7.4 Limited module procedures
- 7.5 Trace antenna designs
- 7.6 RF exposure considerations
- 7.7 Antennas
- 7.9 Information on test modes and additional testi
- 7.10 Additional testing, Part 15 Subpart B disclai
BL-61C WIFI+BLE module
Copyright © 2020 ShenzhenJiXinInteligence Co., Ltd All Rights Reserved
Page
1
of 19
This device is intended only for OEM integrators under the following conditions:
1) The antenna must be installed such that 20 cm is maintained between the antenna and users, and
2) This device and its antenna(s) must not be co‐located with any other transmitters except in
accordance with FCC multi‐transmitter product procedures. Referring to the multi‐transmitter
policy, multiple‐transmitter(s) and module(s) can be operated simultaneously without C2P.
3) For all products market in US, OEM has to limit the operation channels in CH1 to CH11 for 2.4G
band by supplied firmware programming tool. OEM shall not supply any tool or info to the end‐user
regarding to Regulatory Domain change.
USERS MANUAL OF THE END PRODUCT:
In the users manual of the end product, the end user has to be informed to keep at least 20cm
separation with the antenna while this end product is installed and operated. The end user has to be
informed that the FCC radio-frequency exposure guidelines for an uncontrolled environment can
be satisfied.
The end user has to also be informed that any changes or modifications not expressly
approved by the manufacturer could void the user's authority to operate this equipment.
If the size of the end product is smaller than 8x10cm, then additional FCC part 15.19 statement is
required to be available in the users manual:
This device complies with Part 15 of FCC rules. Operation is subject to the following two co
nditions: (1) this device may not cause harmful interference and (2) this device must
accept any interference received, including interference that may cause undesired operation.
LABEL OF THE END PRODUCT:
The final end product must be labeled in a visible area with the following " Contains
FCC ID: 2AVTT-BL61C ". If the size of the end product is larger than 8x10cm, then the following
FCC part 15.19 statement has to also be available on the label:
This device complies with Part 15 of FCC rules. Operation is subject to the following two
conditions: (1) this device may not cause harmful interference and (2) this device must accept
any interference received, including interference that may cause undesired operation.