User's Manual

1
32
USER'S MANUAL
Model：H - 628
Radio Controls
Installing the Earpiece
Note:
Open the cover of the earpiece jack
align the connector and
push fully in .(gure 2)
( Figure 2 )
Antenna
LCD
MENU Button
LED Button
Up Button
Mircophone
On - O / Volume
Headset Jack (MIC/SPK)
Monitor Button
Speaker
LED
Down Button
Display
Note:
No Transmitting , Receiving LCD display Icon .
When you selection high power , the appears
on the display .
When you selection low power , the appears
on the display .
No high and low power switching function when the machine
is in channel CH8~CH14.
When Transmitting LCD display Icon.
When Receiving LCD display Icon.
Channel
Tx/Rx Icon
Scanning
Vox
Battery Level
CTCSS / DCS
Hi / Lo Power Icon
Keypad Lock
Your wireless hand-held portable transceiver contains a low power transmitter.
This product sends out radio frequency(RF)signals when the Push-to-Talk(PTT)
button is pressed. The device is authorized to operate at a duty factor not to
exceed 50%. In August 1996, the Federal Communications Commissions(FCC)
adopted RF exposure guidelines with safety levels for hand-held wireless devices
To control your exposure and ensure compliance with the general population or
uncontrolled environment exposure limits, transmit no more than 50% of the time.
For body-worn operation, this radio has been tested and meets the FXCC RF
Any Changes or modifications not expressly approved by the party responsible
for compliance could void the user's authority to operate the equipment and
should not be made.
exposure guidelines when used with accessories supplied or designated for this
product. Use of other accessories may not ensure compliance with FCC RF
exposure guidelines.
Hold the transmitter approximately 25mm from your face and speak in a normal
voice, with the antenna pointed up and away.
WARNING
This device complies with part 15 of the FCC Rules. Operation is subject to the following
two conditions: (1)This device may not cause harmful interference, and(2)this device
must accept any interference received including interference that may cause undesired
operation.
IMPORTANT NOTE:
Note: This equipment has been tested and found to comply with the limits for a class b digital
device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates,
uses and can radiate radio frequency energy and if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications. However, there is
no guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by turning
the equipment off and on, the user is encouraged to try to correct the interference by one or
more of the following measures:
Reorient or relocate the receiving antenna
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the
receiver isconnected
Consult the dealer or an experienced radio/TV technician for help
SAFETY INFORMATION