Installation Instructions

Any Changes or modifications not expressly approved by the party responsible for compliance could

void the user's authority to operate the equipment.

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:

(1) This device may not cause harmful interference, and

(2) this device must accept any interference received, including interference that may cause undesired operation.

To maintain compliance with the FCCʼs RF exposure guidelines, hold the transmitter and antenna at

least 1 inch (2.5 centimeters) from your face and speaker in a normal voice, with the antenna pointed

up and away from the face.

This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment.

In order to compliance with the FCCʼs RF exposure requirements, the antenna installation must

comply with following:

Users must be fully aware of the hazards of the exposure and able to exercise control over

their RF exposure to quality for the higher exposure limits.

Your wireless hand-held portable transceiver contains a low power transmitter.

This product sends out radio frequency (RF) signals when the Push-to-Talk (PTT) button is pressed.

The device is authorized to operate at a duty factor not to exceed 50%

FCC Caution

PAGE 1
FCC Caution Any Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
PAGE 2
Specific Absorption Rate (SAR) information SAR tests are conducted using standard operating positions accepted by the FCC with the device transmitting at its highest certified power level in all tested frequency bands, although the SAR is determined at the highest certified power level,the actual SAR level of the device while operating can be well below the maximum value.