User's Guide

10
equipment type is in compliance with the essential
requirements and other relevant provisions of RED
Directive 2014/53/EU and the ROHS Directive
2011/65/EU and the WEEE Directive 2012/19/EU;
•Restriction Information
This product can be used in EU countries and regions,
including: Belgium (BE), Bulgaria (BG), Czech
Republic (CZ), Denmark (DK), Germany (DE), Estonia
(EE), Ireland (IE), Greece (EL), Spain (ES), France
(FR), Croatia (HR), Italy (IT), Cyprus (CY), Latvia (LV),
Lithuania (LT), Luxembourg (LU), Hungary (HU), Malta
(MT), Netherlands (NL), Austria (AT), Poland (PL),
Portugal (PT), Romania (RO), Slovenia (SI), Slovakia
(SK), Finland (FI), Sweden (SE) and United Kingdom
(UK).
For the warning information of the frequency
restriction, please refer to the package or manual
section.
•Disposal
The crossed-out wheeled-bin symbol on your product,
literature, or packaging reminds you that in the
European Union, all electrical and electronic products,
batteries, and accumulators (rechargeable batteries)
must be taken to designated collection loc
ations at the end of their working life. Do not
dispose of these products as unsorted mun
icipal waste. Dispose of them according to
the laws in your area.
IC Requirements:
Licence-exempt radio apparatus
This device contains licence-exempt transmitter(s)/re-
ceiver(s) that comply with Innovation, Science and
Economic Development Canada’s licence-exempt
RSS(s). Operation is subject to the following two
conditions:
(1) This device may not cause interference.
(2) This device must accept any interference, including
interference that may cause undesired operation of the
device.
Le présent appareil est conforme aux CNR d’Industrie
Canada applicables aux appareils radio exempts de
licence. L’exploitation est autorisée aux deux
conditions suivantes :
(1) l’appareil ne doit pas produire de brouillage;
(2) l’utilisateur de l’appareil doit accepter tout
brouillage radioélectrique subi, même si le brouillage
est susceptible d’en compromettre le fonctionnement.
RF Exposure Information(if applicable)
•DO NOT operate the radio without a proper antenna
attached, as this may damage the radio and may also
cause you to exceed RF exposure limits. A proper
antenna is the antenna supplied with this radio by the
manufacturer or an antenna specifically authorized by
the manufacturer for use with this radio, and the
antenna gain shall not exceed the specified gain by the
manufacturer declared.
•DO NOT transmit for more than 50% of total radio use
time, more than 50% of the time can cause RF
exposure compliance requirements to be exceeded.