User's Manual

3. Chose the Bluetooth menu in your player and register the device in your player. For

For this, refer to the operation manual of your player. The Device “PBT510WG” Will show in

your player as a selection.

4. If the playback device was recognized,The Bluetooth indicator will blink slowly. After

successful registration, the Bluetooth indicator will stop flashing.

Note:

-Depending on the device manufacturer, you need to perform the registration (PAIRING) again

to connect the devices.

- In case of problems with the pairing of a playback device, Deactivate The WiFi-/and mobile

data function in your playback device.

-The Bluetooth compatibility cannot be ensured for devices (e.g.Mobile phones) getting

released in the future.

-To ensure an optimal connection, Make sure that the battery of your player is completely

charged.

-Some of The mobile phone brands have an energy-saving mode. Deactivate the

energy-saving mode as it can otherwise result in problems during the data transfer through

Bluetooth.

-If a mobile phone on which you are playing music receive a call,The music will be interrupted.

Press the Phone button to accept the call. The sound is replayed by the loudspeakers. Speak

into the microphone on the device or transfer the conversation to your mobile phone. To do this,

observe the overlay in the display of the mobile phone. After you have ended the call, The

devices are connected to each other again and playback continues.

Operation

On/Off

·Turn on the Speaker by holding Standby button. The Bluetooth indicator will start to blink.

Note:

-Automatic connection If supported by your player (e.g. mobile phone), the devices will be

connected automatically. The prerequisite for this is:

1.Devices were already paired with each other.

2.Bluetooth Is Activated In Your Player.

Hold the Standby button to turn off the Speaker .The units are disconnected.

Adjust Volume

·Press the Volume +/- buttons to set the desired volume.

Note:

-The volume on the playback device may not be set too low and not too high either. It could

otherwise result in background noises.