Sound Bar with FM/Bluetooth Music Player Model:CHT940x R R
FCC Warnings WARNING:Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
1. Insert the plug from the supplied AC/DC adaptor to the DC In Jack on the top of unit. 2. Insert the small plug from the supplied AC Power Cord to the AC In Jack on the AC/DC Adaptor. To the wall outlet To the AC In Jack 3. Insert the AC Plug from the supplied to the wall outlet Having AC 100-240V~; 50/60Hz. To the DC IN jack on the top of the unit. NOTE: If Long period of time will not use the unit, unplug the AC Cord from the wall outlet. 1.
2.1 Mounting on the wooden wall You may use 25. 9 in che s 2 pieces screws (Included) 1. Mark the position of the mounting screws on the wall using a pencil. 2. Drill the supplied screws directly into the marks that you have made on the wall and leave approx. 0.3 inch length to hook the sound bar. 3. Put the sound bar onto the mounting screws. Make sure they are firm and stable. 2.2 Mounting on the wall l: a d w e h tig n u o .
Front View 1.Indicator 3. Speakers 3. Speakers 2. Remote Sensor Top View AUX IN2 FM ANT L DC DC IN 16V, 3A AUX IN1 R POWER/ SOURCE VOL- VOL+ PLAY/ PAUSE TUNE- TUNE+ AUX IN2 FM ANT L DC DC IN 16V, 3A AUX IN1 R POWER/ SOURCE 1 2 3 4 5 ) 1. FM ANT ((FM FM receiver Antenna Antenna ) 2. AUX IN 1 jack 3. AUX IN 2 jacks 4. DC IN jack 5. POWER/SOURCE button VOL- VOL+ 6 7 PLAY/ PAUSE 8 TUNE- 9 TUNE+ 10 6. VOL- ( Volume Down ) button 7. VOL+ ( Volume Up ) button 8.
1 2 TUNE- TUNE+ MO/ST SOURCE BASS - TREBLE- VOL- BASS+ TREBLE+ VOL+ EQ 8 3 4 5 9 10 6 11 6. BASS +/- buttons 7. ( Mute ) button 8. EQ ( Equalizer ) button 9. ( Play/Pause ) button 10. VOL ( Volume ) +/- buttons 11. TREBLE +/- buttons 1. Power ON/OFF button 2. TUNE-/ ( Skip Backward ) button 3. TUNE+/ ( Skip Forward ) button 4. MO/ST ( Mono/Stereo ) button 5.
- First Time Use Remove and discard the insulation tab as figure on the right. - If the battery is consume, replace it as below: 1. Push and slide out the battery holder as figure 1 below. 2. Replace the battery with a new CR2025 button cell as the polarity markings on the rear of the Remote Control. 3. Close the battery holder. Fig.1 Fig.2 Fig.3 BATTERY PRECAUTIONS Folloe these precautions when using a battery in this device: 1. Use only the size and type of battery specified. 2.
GENERAL OPERATIONS 1. Connect the AC/DC adapter to the unit and wall outlet as the previous procedure. The Red Indicator will light. 2. Press the POWER/SOURCE button on the unit or press the Power button on the remote control to power on the unit from standby mode. The color of the Indicator will turn to correspondence color. 3.
BLUETOOTH PARING AND PLAYBACK Blue tooth In first time use or re-pairing to new BT Device, pairing the unit to the external BT Device as follows: 1. Power on the unit as previous procedures. 2. Press the POWER/SOURCE button on the unit or press the SOURCE button on the remote control repeatedly until the color of the Indicator turns to Blue. 3. Power on the external BT Device and enter to searching mode. Start pairing as the on screen instructions on the external BT Device.
AUX IN 1 : LISTEN TO EXTERNAL AUDIO DEVICES 1. Connect the Headphone/Earphone; Aux out jack or Line out jack from the external audio player (such like MP3 player; Discman … etc) to the AUX IN 1 jack on the top of unit by the supplied Audio Connection Cable as the figure below: Audio Player FM ANT To Phone Jack AUX IN1 L R AUX IN2 DC 2. Connect the unit to the power as previous procedures. DC IN 16V, 3A 3.
TROUBLESHOOTING GUIDE Check the followings before requesting service SYMPTOM No power No sound Sound distortion POSSIBLE CAUSE POSSIBLE SOULTION Power AC/DC adapter not connected Connect the power AC/DC adapter. The unit is in Standby mode Press the Volume in minimum position Raise volume level by pressing the VOL (Volume) + button. The paired/connected device is not in payback mode Play music/movie in the paired/connected device as usual and make sure the volume level of it is in high level.
Power Source...................................................................................... DC --- 16V; 3A, Radio Coverage..........................................................................................FM 87.5-108 MHz Receiver Frequency .................................................................................. Impedance of Speakers: Loud Speakers .............................................................................................. 6 Ohm,10 W x 2 Woofer ....................
LIMITED WARRANTY Craig warrants this product to be free from manufacturing defects in material and workmanship under normal use for a period of 90 days from date of purchase. If service is required, please return the product to the store where it was purchased for exchange; or, pack the unit in the original packing material with all accessories if applicable, a copy of your sales receipt and a Cashier’s check or Money Order for $15.00 (to cover shipping and handling costs) payable to Craig Electronics Inc.
