WALL MOUNTABLE 2.1-CHANNEL BLUETOOTH SOUNDBAR SPEAKER WITH FM RADIO USER MANUAL JSBW-650 PLEASE READ THIS USER MANUAL COMPLETELY BEFORE OPERATING THIS UNIT AND RETAIN THIS BOOKLET FOR FUTURE REFERENCE.
DEAR JENSEN® CUSTOMER Selecting fine audio equipment such as the unit you've just purchased is only the start of your musical enjoyment. Now it's time to consider how you can maximize the fun and excitement your equipment offers. This manufacturer and the Electronic Industries Association's Consumer Electronics Group want you to get the most out of your equipment by playing it at a safe level.
IMPORTANT SAFETY INSTRUCTIONS When used in the directed manner, this unit has been designed and manufactured to ensure your personal safety. However, improper use can result in potential electrical shock or fire hazards. Please read all safety and operating instructions carefully before installation and use, and keep these instructions handy for future reference. Take special note of all warnings listed in these instructions and on the unit. 1.
16. Battery shall not be exposed to excessive heat such as sunshine, fire or the like 17. Danger of explosion if battery is incorrectly replaced. Replace only with the same or equivalent type. 18. Do not attempt to dismantle, open or repair this product yourself. If a fault occurs, seek advice from your local qualified service technician or contact the distributor via the telephone number at the back of this instruction manual. 19. Caution marking and nameplate are located on bottom of product.
improvement centers everywhere, and apply these pads to the bottom of the rubber 'feet' before you place the product on fine wooden furniture. ACCESSORIES 1 x AC Adaptor 1 x Remote Control, 1 x Stereo Audio Connection Cable with 3.
Mounting the JSBW-650 on a wooden wall It’s important to be sure there are no electric, gas or water lines located behind the wall where you are attaching the sound bar. We recommend having this speaker professionally installed. Use the included wall mounting accessories and template to attach the sound bar to the wall. 1. Use the supplied wall mounting template to make drill hole marks on the wall. Make sure the marks are level before drilling. 2.
screws into the anchors and tighten until the screw head is fully inserted and flush with the metallic bracket. 5. Place the sound bar onto the mounting brackets. Make sure the sound bar is attached firmly to the wall.
1. MODE INDICATOR LED 2. FM WIRE ANTENNA 3. AUX-IN 1 L/R RCA CONNECTORS 4. DC IN JACK 5. AUX-IN 2 JACK 6. FM TUNE + 7. VOLUME + BUTTON 8. POWER ON/STANDBY ; SOURCE BUTTON 9. VOLUME - BUTTON 10. REMOTE INFRARED SENSOR REMOTE CONTROL 1. POWER ON/STANDBY BUTTON 2. VOLUME – BUTTON 3. SOURCE BUTTON 4. BASS – BUTTON 5. TREBLE – BUTTON 6. TUNE-/SKIP BACKWARD 7. BLUETOOTH PLAY/PAUSE BUTTON 8. MUTE BUTTON 9. VOLUME + BUTTON 10. BASS + BUTTON 11. BLUETOOTH PAIR BUTTON 12. TREBLE + BUTTON 13. EQ BUTTON 14.
GETTING STARTED CONNECTING THE JSBW-650 TO EXTERNAL AUDIO DEVICES You can connect the JSBW-650 audio input to the audio output of your television or DVD Player. Please see figure below. NOTE: 1. Make sure that the power is turned off when connecting or disconnecting the other devices. Make sure that the other devices are connected to the correct terminals. 2. This unit is not magnetically shielded and may cause color distortion on the screen of some TVs or video monitors.
2.) Removed the exhausted battery and then install 1 new “CR2025” lithium battery according to the polarity diagram on the battery compartment. 3.) Insert the battery holder into the remote control and make sure it locks into place. NOTE: Only use a well-known brand of battery to ensure the longest life and best performance. Battery Precautions Replacement of batteries must be done by an adult. The supply terminals are not to be short-circuited.
HINTS FOR BEST RECEPTION: To obtain the best FM/FM Stereo reception, unwrap and fully extend the FM Antenna and adjust the position of the wire for best station reception NOTE: Automatic tuning depends on the signal strength of the broadcasting station, so weak stations may be skipped. You can manually tune to find the weak stations if a station gets skipped. With strong signals, the tuner may stop before it reaches the actual broadcast frequency, so you may need to manually tune for the best reception.
2.) If your Bluetooth enabled device does not support A2DP, it will not play the music through the speaker, even after it's paired (linked). 3.) If you are pairing (linking) your computer to the JSBW-650 using Bluetooth, you may need to set the JSBW-650 as your computer’s default sound device. CONTROLLING THE MUSIC PLAYBACK ON YOUR BLUETOOTH DEVICE USING THE REMOTE CONTROL 1. Press the POWER button to turn on the unit. 2.
NORMAL POP JAZZ CLASSIC ROCK In addition, you can adjust treble and bass effects by using the TREBLE & BASS +/buttons. MUTE (Remote Control Only) - Press the MUTE button on remote control to mute the sound output from speaker temporarily, the Mode Indicator LED will flash. - Press the button again to resume to normal speaker playback.
NOTE: If you connect this unit to the Line-Out Jack of your external device then you only need to adjust the volume control of this unit. If you connected the Headphone Jack of your external device then you may need to adjust both the volume control of your external device and the volume control of this unit to find the most desirable volume setting. Press the POWER button to turning off the unit when you finish listening. Don't forget to switch off the power of your external device as well.
Noise or sound distorted on FM broadcast range Station not tuned properly for FM. Volume level is set too high. Sound is distorted Sound source is distorted. Unit gets warm after extended play at This is normal. high volume Bluetooth operating range Full extend or rotate the wire antenna for best reception. Retune the FM broadcast station. Decrease the volume. If the external device original sound source is of poor quality, distortion and noise are easily noticed with high-power speakers.
90 DAY LIMITED WARRANTY AND SERVICE VALID IN THE U.S.A ONLY SPECTRA MERCHANDISING INTERNATIONAL, INC. warrants this unit to be free from defective materials or factory workmanship for a period of 90 days from the date of original customer purchase and provided the product is utilized within the U.S.A. This warranty is not assignable or transferable.