User Guide

16
Frequently Asked Questions
1. Can I share with family and friends?
Yes, you can share your cameras with family and friends who will have
access to view the camera and control your bulbs, plugs, and other
Geeni devices. In the Geeni app, press the Profile button and click on the
“Device Sharing” button, and you will be able to give or revoke sharing
permissions. In order to share, the other user should already have
downloaded the Geeni app and registered a new account.
2. How does the pre-installed microSD card work:
The camera has a preinstalled 16GB microSD card and will continuously
record until the card is full. This video is encrypted and only viewable
through the Geeni app on your phone; you can remove the pre-installed
microSD card, in order to install a larger capacity card, but you cannot
view the footage saved on the microSD card outside of the Geeni app.
3. How much video can the camera record?
Depending on the video quality, the camera will use around 1GB of
storage to record 24 hours of footage. This can mean an entire day of
continuous footage, or multiple days of motion-only recording. As the card
fills up, the oldest footage will be automatically replaced by new video.
If you would like to increase your internal storage space, visit MyGeeni.
com for an instructional video on how to open up the camera and install a
larger microSD card.
5
Blinking
Ready to connect
Solid
Connected
3 Plug In.
How do I reset my device?
A reset button is located on the cord connected to the camera. Reset the
camera by holding down the button for several seconds.
Important: Set up and connect the camera before mounting. Set up works
best near your home router. If the camera is disconnected from power after
setup, it will automatically reconnect when plugged in again.
Note: The camera will appear inactive while booting up—allow two minutes
for the light to activate.
What does the blinking light mean?
Reset
Button
Connected
to Camera