User's Manual

- 21 -
Don’t install any article above the air chamber or where the air chamber
may take up during expansion, including stationary or mobile wired
equipment. Incorrect installation of onboard wired equipment may result in
serious damage when the air chamber expands.
Plane
It’s forbidden to use the equipment when taking a plane. Please turn off the
equipment before boarding. Using wireless phones will result in hazard to
operation of the plane by interfering with the wireless telephone network. In
addition, using wireless phones on the plane is illegal.
In places where it may cause explosion
Please turn off the equipment where it may cause explosion, and abide by all
the word and graphic directions. Places where it may cause explosion
include the places where it is suggested to turn off the auto engine under
normal conditions. In such places, spark may lead to explosion or fire
hazard, and result in personal injury or even death. Please turn off the
equipment in gas stations, such as near the gas pump in the station. Please
abide the specifications on restricted usage of radio equipment in fuel depot
(where the fuels are kept and distributed), chemical plant or places
conducting blasting. Places with potential explosion hazard are always (but
not all) provided with clear directions, including under the deck of ship,
chemical transportation or storage facilities, or places where the air contains
chemical matters or particulates (such as grains, dust or metal dust).
Emergency call
Like other wireless phones, the equipment uses radio signal, wireless and
ground network, and is provided with programmable functions by the user.
Thus, it is not guaranteed that the call can be put through in any
circumstances. Therefore, it is not suggested to rely on any wireless
equipment for important calls, such as medical treatment and first-aid.
Making emergency phone calls:
1. Turn on the equipment firstly and check whether the signal is strong
- 22 -
enough. In certain networks, it may be required to insert the valid SIM
card correct into the equipment.
2. If necessary, press the key of finish repeatedly.
FCC Statement
1. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference.
(2) This device must accept any interference received, including interference that may cause undesired operation.
2. Changes or modifications not expressly approved by the party responsible for compliance could void the user's
authority to operate the equipment.
NOTE:
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15
of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a
residential installation.
This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance
with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to
correct the interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
SAR Information Statement
Your wireless phone is a radio transmitter and receiver. It is designed and manufactured not to exceed the emission
limits for exposure to radiofrequency (RF) energy set by the Federal Communications Commission of the U.S.
Government. These limits are part of comprehensive guidelines and establish permitted levels of RF energy for the
general population. The guidelines are based on standards that were developed by independent scientific
organizations through periodic and thorough evaluation of scientific studies. The standards include a substantial
safety margin designed to assure the safety of all persons, regardless of age and health. The exposure standard for
wireless mobile phones employs a unit of measurement known as the Specific Absorption Rate, or SAR. The SAR
limit set by the FCC is 1.6 W/kg. * Tests for SAR are conducted with the phone transmitting at its highest certified
power level in all tested frequency bands. Although the SAR is determined at the highest certified power level, the
actual SAR level of the phone while operating can be well below the maximum value. This is because the phone is
designed to operate at multiple power levels so as to use only the power required to reach the network. In general, the
closer you are to a wireless base station antenna, the lower the power output. Before a phone model is available for
sale to the public, it must be tested and certified to the FCC that it does not exceed the limit established by the
government adopted requirement for safe exposure. The tests are performed in positions and locations (e.g., at the ear
and worn on the body) as required by the FCC for each model. The highest SAR value for this model phone when
tested for use at the ear is 1.190W/Kg and when worn on the body, as described in this user guide, is
0.960W/Kg(Body-worn measurements differ among phone models, depending upon available accessories and FCC
requirements). While there may be differences between the SAR levels of various phones and at various positions,
they all meet the government requirement for safe exposure. The FCC has granted an Equipment Authorization for
this model phone with all reported SAR levels evaluated as in compliance with the FCC RF exposure guidelines.
SAR information on this model phone is on file with the FCC and can be found under the Display Grant section of
http://www.fcc.gov/ oet/fccid after searching on
FCC ID: ZSHS-350 Additional information on Specific Absorption Rates (SAR) can be found on the Cellular
Telecommunications Industry Asso-ciation (CTIA) web-site at http://www.wow-com.com. * In the United States and
- 23 -
Canada, the SAR limit for mobile phones used by the public is 1.6 watts/kg (W/kg) averaged over one gram of tissue.
The standard incorporates a sub-stantial margin of safety to give additional protection for the public and to account
for any variations in measurements.
Body-worn Operation
This device was tested for typical body-worn operations. To comply with RF exposure requirements, a minimum
separation distance of 15mm must be maintained between the user’s body and the handset, including the antenna.
Third-party belt-clips, holsters, and similar accessories used by this device should not contain any metallic
components. Body-worn accessories that do not meet these requirements may not comply with RF exposure
requirements and should be avoided. Use only the supplied or an approved