User Manual

User’s manual

Package Includes

1 Bluetooth speaker

2USB to Micro USB cable

3 3.5mm Auxiliary Cable

Features

Durable, shock and weather-resistant silicone wrap

On-board playback and volume controls

Auxiliary input to connect speaker with non-Bluetooth devices

Charge it

 Plug the micro USB cable into the micro USB port under the silicone cover on the button

right corner of the speaker, and connect the other end of cable to either a computer USB port

or to a USB-compatible car or wall charger.

 A solid red LED light will appear through the grill on the back of the speaker to indicate

when the KTS-86 is charging, even while speaker is turned off.

 When charging is complete ,the red LED light will turn off.

 Charging time is approximately 2 hours

Pair & Connect with a New Device

 Power on the kts-86 speaker(refer to the “Turn it on” section)

 The KTS-86 will emit a tone, and then LED light on the back of the speaker will begin to

flash blue as it tries to reconnect with a previous device. If it cannot reconnect, the LED light

will begin to quickly flash blue to indicate that the speaker is now ready to be paired with a

new device.

 On your Bluetooth enabled smartphone, tablet or media player, navigate to the Bluetooth

setting menu, turn on the Bluetooth feature, and search for a new devices.

 After a few seconds you will see “KTS-86”listed

 Tap this model to select it. The LED will turn a solid blue. You are now paired, connected

and ready to play.

 Alternatively you can connect any non-Bluetooth device using the included 3.5mm AUX

cable together with the AUX input located under the silicone cover the bottom right corner of

the speaker. While plugged in via the AUX input, the LED light will slowly flash blue and

Bluetooth on the speaker will automatically turn off.

Power On/Off

 Press & hold the power button on the right side of the speaker for 2-3 seconds to turn on the

speaker and automatically reconnect with the last Bluetooth device.

 The KTS-86 will emit a tone, and the LED light on the back of the speaker will glow blue to

indicate that the speaker is now powering on.

 To turn the KTS-86 speaker off, press &hold the power button again for 2-3seconds.The

PAGE 1
User’s manual Package Includes 1 Bluetooth speaker 2USB to Micro USB cable 3 3.5mm Auxiliary Cable Features Durable, shock and weather-resistant silicone wrap On-board playback and volume controls Auxiliary input to connect speaker with non-Bluetooth devices Charge it     Plug the micro USB cable into the micro USB port under the silicone cover on the button right corner of the speaker, and connect the other end of cable to either a computer USB port or to a USB-compatible car or wall charger.
PAGE 2
speaker will emit a tone to indicate that the KTS-86 is now powering off. Reconnect to Bluetooth     You only need to pair your Bluetooth device with the KTS-86 once. With your previously paired device’s Bluetooth turned on and in range, power on the KTS-86. The speaker will automatically reconnect to the last Bluetooth device it was connected to.
PAGE 3
Important Waterproof /Safety Information IMPORTANT:DO NOT submerge the KTS-86 in water. This device is not intended to function properly after being under water.  Before using the KTS-86 in a wet environment, make sure the silicone cover over the AUX and micro USB input ports on the back of the speaker is fully closed and secured. If water gets into either port, the speaker may not function properly  The speaker is rated IPX4.