BLUETOOTH SPEAKER MANUAL MODEL NO.
Specification Wireless version: 4.2+EDR Speaker driver unit size: 4 INCH Output power: 5W Speaker impedance: 4 Ohm Frequency response: 100Hz-20KHz Signal to noise ratio: >=85dB FM scan range: 87.5-108.0Mhz Wireless range: 10 meter Max memory USB/SD: 32GB USB charging: DC 5V Battery capacity: 800mAh Backup time via wireless mode: Approx 1 hours at max volume Backup time via USB mode: Approx 1 hours at max volume Charging via USB port (PC): 1.
Connect to Bluetooth device Turn on the unit and switch on your mobile Bluetooth, then search for the speaker model name "KTS-1050A"and pair the device. Once device is paired, Bluetooth will automatically connect when unit is turned on subsequently. 1. OFF/ON: To turn ON/OFF the speaker. 2. DC 5V: Plug the Micro USB cable to the speaker and connect other end USB port to the power source. (DC 5V) Aux: Audio input jack when connect.
AUX-IN AUX-IN, Using the audio cable into AUX jack, press M to switch to Aux in Mode. Long press and button to turn down and turn up the Volume. In the AUX IN mode, it couldn’t shift Prev and Next by Bluetooth speaker, but can control by connection device. USB/TF Card Insert the U flash memory or Micro-TF card into the USB/TF slot. it will read the MP3 format music automatically. Press ll to Play/Pause, short time press and to Prev. and Next, Long press and button to turn down and turn up the Volume.
FCC Statement This device complies with Part 15 of the FCC rules. Operation is subject to the following two conditions: 1) this device may not cause harmful interference, and 2) this device must accept any interference received, including interference that may cause undesired operation. Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules.
