User's Manual

20
to overweight.
※ Strongly recommend to use UMPC attached stylus to touch screen and operate
※ Recommend to buy the special wipe for LCD to clean the screen. Please don’t wipe
fiercely, otherwise it will damage the screen
※ Please don’t use chemical cleaners to wipe the LCD screen.
※ LCD screen should avoid touching with hard objects, such as buttons, watchband and
buckle etc, otherwise it will be scratched.
※ LCD screen absorbs the dust due to static,please use soft dry cloth to wipe it if have
dust,don’t remove it by hand to avoid leaving the fingerprint on the screen.
※ Don’t let water droplet immersed into the internal LCD screen,which might lead to
damage the internal components of LCD screen.
※ Please open and close upper cover of LCD screen to avoid loosening the cable due to
overweight,which lead to the screen flicker.
※ Battery
※ Detail information on use and maintenance of batteried,please refer to 5-2 battery system.
※ Make sure recycle the wasted battery, please properly deal with wasted
battery according to your local law about discarded electrinic products
※ Please don’t leave the battery close to fire or throw into the fire, otherwise it may cause
explosion
※ Please don’t try to dismantle or recombine the battery. Prevent the battery from short
circuit
※ Room temperature (20-30 Celsiur Degree) is the best working temperature for battery. If
the working tenperature is too high or too low, it will decrease the battery life
※ Hard Disk
※ Try to use UMPC in stable environment and avoid using UMPC in shaking place
※ Hard disk is weak in the status of boot-strap and shutdown. When UMPC switches on,
the rotate speed of motor in hard disk is unstable. If it is shaked, it may cause bad track.
When UMPC shuts down, the axletree doesn’t stop. If UMPC is moved at this monment,