User's Manual

Page 18 of 22
DTMF signaling, press corresponding programmable keys “Call 1” “Call2”, the codes can be
transmitted.
6.7 Talkaround
In the communication network, you can expand communication range through the repeater, but
when the mobile radio is out of the communication range, you can connect with other radio in the
talkaround method.
Switch the talkaround or repeater mode through “Talkaround” key.
6.8 Scan
The station can be programmed to scan multiple channels to receive signals from them.
6.8.1 Start/End Scan Function
a) Press the key programmed to “Scan”, the Scan function is entered. During the scan,
channels in the scan list of the phone will stop will signals are found, the phone will stay
at the channel with signals till the signals disappear, if the time delay between the
signals disappear and the scan resumes, the phone will stay at the current channel if no
signal is received during the dime delay.
b) Priority Scan:
You can select one channel in the scan list as the priority channel, which has the highest
priority during the scan, during the scan, a non-priority channel in the scan list will be
scanned first, and then the priority channel, and then the next non-priority channel, and
then the priority channel again, and the scan goes on in this cycle.
If the priority channel and the flyback period are set in the Scan list, when the phone
receives signals in a non-priority channel, it is in the Scan Stopped status and will fly
back the priority channel in a certain cycle, if there are signals in the priority channel, it
will stay at the priority channel, if there are no, it will return to the original channel.
c) There are the following options for the back channel during the scan set by the dealer
(i.e., the transmitting channel during the scan):
Select the preset channel: The phone transmits signals from the channel where the scan
is started.