User's Manual

Page 19 of 22
Preset channel + current channel: if the phone is at the Scan Staying status, it will
transmit signals from the current channel, otherwise, it will transmit signals from the
channel where the scan is started.
Priority channel: The priority channel preset in the Scan list.
Priority channel+ current channel: if the phone is at the Scan Staying status, it will
transmit signals from the current channel, otherwise, it will transmit signals from the
priority channel.
Last calling receiving channel: The channel where the phone has received signals for
the last time.
Last transmission + Current channel: if the phone is at the Scan Staying status, it will
transmit signals from the current channel, otherwise, it will transmit signals from the
channel where it has transmitted signals for the last time.
6.8.2 Nuisance Delete
If a channel continuously generates noise or interference, press the key to remove this
channel from the scan list temporarily.
Note: the priority channel can't be removed and the last one in the scan list, either.
Quit the Scan mode and enter it again, the deleted channel will be added to the scan list
again.
6.9 Transmission Begin and Transmission End Signals (PTT ID)
Transmission Begin and transmission End identification signals are used for continuing with or
stopping certain repeaters and phone systems.
If Transmission Begin has been set, when you press the PTT switch, the ID signals will be
transmitted.
If Transmission End has been set, when you release the PTT switch, the ID signals will be
transmitted.
If both have been set, the ID signals will be transmitted respectively when you press and release
the PTT switch.