User's Manual
Table Of Contents
- 1. Package-opened Inspection
- 2. Preparation
- 3. Radio Overview
- 4. Basic Operation
- 5. Programmable Key Function
- 6. Auxiliary functions
- 6.1 TOT Timer
- 6.2 battery saving
- 6.3 Low battery alarm
- 6.4 Number announcement
- 6.5 Quite Talk (QT) / Digital Quiet Talk (DQT)
- 6.6 Dual Tone Multi-Frequency (DTMF) Coding
- 6.7 Talkaround
- 6.8 Scan
- 6.8.1 Start/End Scan Function
- 6.8.2 Nuisance Delete
- 6.9 Transmission Begin and Transmission End Signals (PTT ID)
- 6.10 Lone worker
- 6.11 Emergency Alarm
- 7. Wired Clone Mode
- 8. Trouble Shooting Guide
- 9. Major Specifications
Page 20 of 22
6.10 Lone worker
If Lone worker is set to be enabled, press the key “Lone worker” to enable the Lone Worker Mode.
Start the Lone worker timer and when the preset Lone worker time is reached, the station will
alarm, after the alarm time, the station will enter the Emergency Alarm Mode and give out the
Emergency Alarm.
In the Lone worker Mode, press the “Lone worker” key again to quit the Lone worker mode.
In the Lone worker Mode, press the key programmed for “Lone worker reset” (the specific key to
select lone worker reset mode) or any key (any key to select lone worker reset mode), the Lone
worker timer will start timing again.
6.11 Emergency Alarm
Press the key programmed for “Emergency Alarm” (the time of pressing must be longer than the
de-bounce time of the emergency alarm switch) to enter the Emergency Alarm mode. “E” will be
displayed. You can set alarm tone according to the programming software or send your own ID or
background tone to your friend or the system.
In the Emergency Alarm Mode, press the key “Emergency Alarm Off” to quit the Emergency
Alarm Mode and disable the alarm tone or stop sending it and resume normal operation.
7. Wired Clone Mode
If the wired clone function is enabled, the radio will not quit after entering the wired clone mode. To
return to normal user mode, the user needs to restart the machine.
The operating steps go as follows:
1. Press [P1] keys for power-on until show “C” and enter the clone mode. If the function is disabled, it
will enter the user mode.
2. Connect the slave radio with the wired clone cable first, and then turn on.
3. Press key [P2] on the master radio for starting clone. During transmitting the data, the master radio
lightens red, and the slave radio lightens green and indicates “P”. After the slave radio receiving all
the data, the red light on the master radio is off, and the slave radio restarts.
4. You can keep copying according to step 3 above.
Note: The master displays success and the slave automatically restart upon successfully receipt of all
data.