User Manual

11
the Activation/Prohibition of Wired Cloning Mode. However, the wired cloning setting on the
host radio won’t be changed.
After pressing the PTT button, if the green indicator flashes twice and one beep sounds, it
indicates the sub radio is in the state of Activation of Wired Cloning; if the red indicator
flashes twice and two beeps sound, it indicates the radio is in the state of Prohibition of Wired
Cloning.
3) In the cloning mode, press the Side Button 2 on the host radio, and then red indicator flashes
and it begins cloning. After cloning, the indicator turns dim.
Note: You can activate or prohibit the wired cloning mode by PC programming software. If the
wired cloning mode is prohibited the radio cannot enter the wired cloning mode.
■ Auxiliary Functions
TOT (Time-out Timer)
1) TOT (Time-out Timer)
a) Time-out timer is to prevent any caller from occupying one certain channel and radio
transmitting overlong.
b) You can program the time-out timer, i.e. the time the radio can transmit continuously. If the
radio has been transmitting continuously longer than the preset time, the radio will stop
transmitting and warning tone sounds, and please release the PTT button.
2) TOT Re-key
a) TOT re-key specifies the time when transmission is prohibited after the time-out timer is
activated.
b) During the time of transmitting prohibition, if you press the PTT button, warning tone sounds
and transmitting is prohibited.
3) TOT Pre-alarm
a) Before the time-out timer stops transmitting, the radio sounds pre-alarm tone.
b) After the alarm tone, if the transmitting time is longer than the preset time limit, the time-out
timer will be activated.
4) TOT Reset
a) TOT Reset is the delay time between releasing the PTT button and resetting the time-out
timer.
b) If the time of releasing the PTT button is shorter than the TOT Reset, the countdown of
transmitting prohibition will continue.
Battery Save
The dealer can program the battery save type.
If the battery save function has been set, 10 seconds after no signals being received or no
operations being conducted, the radio enters the battery save mode. It will exit the battery save
mode automatically after receiving signals or being conducted.
Battery Save Types: 1:1, 1:2, 1:4 and OFF.