User's Manual

7. Wired Clone Mode
If the wired clone function is enabled, the radio will not quit automatically after entering the
Wired Clone Mode. To return to normal user mode, the user needs to restart the radio.
The operating steps go as follows:
1. Press side button 2 to turn on the radio and enter Clone Mode. If the wired clone function is
disabled, the radio will enter User Mode.
2. Connect the slave radio with the master radio by a clone cable. Then turn on the slave radio.
3. Press side button 1 of the master radio, the cloning starts. During the data transmission
process, the master radio will light up red, and the slave radio will light up green. When the
cloning is finished, the red LED of the master radio will be off, and the slave radio will restart
automatically.
4. You can continue to clone data according to step 3.
Note: The wired clone function can be enabled or disabled by the PC programming software.
Once the wired clone function is disabled, the radio cannot enter Wired Clone Mode.
8. Troubleshooting Guide
No. Problem Causes and Solutions
1 Power on failure A. The battery and the radio are not reliably connected. Please
reinstall the battery.
B. The protective tube of the power supply is burnt out. Please
change it.
C. The power switch is in failure. Please change it.
D. The battery is out of power, please recharge it or change it.
E. The CPU is broken, please change it.
2 Phase lock loop
unlocked (Beeping)
A. The channel frequency setting is out of range, please reset the
channel data.
B. The crystal oscillator of phase lock loop is broken, please
change it.
C. The oscillating tube is broken, please change it.
D. The phase lock loop IC is broken, please change it.
3 No talkback A. The frequencies of the two radios are not the same. Please select
a channel which has the same frequency with that of the other
radio.
B. The CTCSS/DCS signals of the two radios are not the same.
Please reset it.
C. The radio is out of effective communication range.
4 No Rx signals A. The antenna is in poor contact. Please fasten the antenna head.
B. The HF amplifying tube is broken, please change it.
C. The squelch level is so high that the squelch cannot be opened.
Please reset the squelch level.
D. The mixer tube is broken, please change it.
E. The FM processing IC is broken, please change it.