User's Manual

⑤ Receiving
Release the button, the radio will return to the receiving status. The dealer may have
programmed CTCSS/DCS signaling in your radio. On the channels with CTCSS/DCS signaling
programmed, you can only hear calls from other radio with the same CTCSS/DCS.
5. Functions of Programmable Buttons
The dealer can assign one of the following auxiliary functions to the top button, side button 1
or side button 2.
No. Function Description
0 None No function is assigned.
1 Voice
Announcement
Selection
Press the preprogrammed “Voice Announcement Selection” button to
switch the language and mode of voice announcement, meanwhile, the
channel number being broadcasted can be heard.
2 Talkaround When the preprogrammed “Talkaround” button is pressed, the
transmitting frequency will be the same with the receiving frequency if
the radio transmits again.
3 Lone Worker Press the preprogrammed “Lone Worker” button to enable/disable the
lone worker function.
4 Emergency
Alarm
Press the preprogrammed “Emergency Alarm” button to send alarm
tone according to the setting of the programming software or send your
ID or background sound to your partner or the system.
5 Emergency
Alarm Off
Press the preprogrammed “Emergency Alarm Off” button to quit the
Emergency Alarm Mode.
6 Scan Press the preprogrammed “Scan” button to enable/disable the system
scan function.
7 Nuisance Delete
(temporary)
If the scan function of the radio is enabled, and the radio stays at the
noise channel, press the preprogrammed “Nuisance Delete” button to
delete the noise channel temporarily.
8 High/Low Power
Switch
Press the preprogrammed “High/Low Power Switch” button to switch
between high and low transmitting power of the radio.
9 Momentary
Monitor
Press and hold the preprogrammed “Momentary Monitor” button to
disable CTCSS, DCS signaling, and release the button to resume
normal operation.