User's Manual Part 1

the scan function has been activated, the transceiver can start
scanning.
1) Press the button set as Scan or Scan + Temporarily
Delete to start scanning.
2) The transceiver will start scanning from the
current channel and scan channels one by one in the
consequence of channel No. and the LED flashes green.
3) When a signal is detected on a channel ,
scanning pauses and LED lights green.
4) You can select a channel to make a call by pressing
the
PTT button during anytime of scanning.
5) Press again the button set as Scan or
Scan + Temporarily Delete to end scanning.
Priority Scan
During scanning, if the priority channel has been set
on the transceiver, when the priority channel receives
a signal the transceiver will automatically switch to
the priority channel even the normal channel is receiving
signals at that time. And the transceiver will stay on the
priority channel till that signal disappears. The dealer can set
the delay time between signal disappearing and continuing
scanning.
Temporarily Delete
When scanning pauses on a channel, press and
hold the button programmed as
Temporarily Delete or Scan
+ Temporarily Delete for 1 second to delete
this channel temporarily from the scanning list.
Note:
of scanning channels is less than 2, you cannot
delete any channel, either.
After exiting scanning mode and entering it
again, the temporarily deleted channel will be added in the
scanning list again.
6.4 CALL 1/CALL 2
If the dealer has programmed DTMF, KDC1200, 2-
Tone or
5Tone signaling on the current channel
,
press the programmable side button (CALL 1 or
CALL 2) to send the stored DTMF, KDC1200, 2-Tone or
5-Tone code.
While in transmitting LED lights red; and after
transmission except KDC1200 LED flashes orange till
the effective time expire, within which you can
receive calls from other transceivers.
6.5 Scrambler (Backup)
Scrambler offers voice security. This function set
on both communication parties can avoid other transceivers
using the same frequency to acquire your private information.
When pressing the side button programmed as
Scrambler, the third party is unable to listen to your talking
voice clearly.
If Scrambler Backup option is not activated, the
transceiver will not be in Scrambler state after it is
switched on once again, whereas the Scrambler state will
be stored.
6.6 VOX