User's Manual

- 69 -
4.13.3 Call Setup
Caller ID: You can select the system presetting provided by the network
operator to hide or send the number. The default setting by the factory
is Set By Network.
Note: This function depends on the network so selecting “Hide ID” may
cause failure to dial. Before using this function, please test it by talking
over the phone to ensure that everything is ok.
Call Waiting:
− Activate: When you activate this function, the mobile phone will
be connected with the network. After a while, the network will
respond by sending the message to OK your operation. When
Call Waiting is activated, you will receive an alert from the network
if someone calls you while you are attending another call, , and
the phone number of the caller will appear on the screen.
− Deactivate: If you cancel the Call Waiting function, you will not
receive any alerts from the network if someone calls while you
are attending another call.
− Query Status: With this function you can make enquiries from the
network about the current status.
Call Divert: Call Diverting is a network service that enables the
incoming call to be transferred to another phone specified by you. Enter
Call Setting, select Call Divert and press OK to use the function.
− Divert All Voice Calls: When you activate this function, all
incoming calls will be diverted to the specified number. Select
Activate or Deactivate to connect the phone with the network.
After a while, the network will respond and advise you about the
status of the Call Divert function. .
− Divert If Unreachable: When you activate this function, the
incoming call will be diverted to the specified number if your