User's Manual

ManualsBrandsShenzhen KVD Communication Equipment ManualsCell PhonesGSM/WCDMA Smartphone

User Manual

FCC Warning:

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits

are designed to provide reasonable protection against harmful interference in a residential installation.

This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may

cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this

equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is

encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and receiver.

• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

• Consult the dealer or an experienced radio/TV technician for help.

Caution: Any changes or modifications to this device not explicitly approved by manufacturer could

void your authority to operate this equipment.

This device complies with part 15 of the FCC Rules. Operation is subject to the following two

conditions: (1) This device may not cause harmful interference, and (2) this device must accept any

interference received, including interference that may cause undesired operation.

Specific Absorption Rate (SAR) Information

SAR tests are conducted using standard operating positions accepted by the FCC with the Phone transmitting at its highest certified power level in all

tested frequency bands, although the SAR is determined at the highest certified power level, the actual SAR level of the phone While operating can be well

below the maximum value, in general, the closer you are to a Wireless base station antenna, the lower the power output. Before a new model phone is an

available for sale to the public, it must be tested and certified to the FCC that it does not exceed the exposure limit established by the FCC, Tests for each the

FCC that it does not exceed the exposure limit established by the FCC, Tests for each required by the FCC. The maximum SAR value is W/Kg.

For body worn operation, this model phone has been tested and meets the FCC RF exposure guidelines when used with an accessory designated for this

product or when used with an accessory that contains no metal and that positions the handset a minimum of 10 mm from the body. Non-compliance with the

above restrictions

FCC ID:

2ADTE-X20

1.545