User's Manual

71x102mm
Controls and Indicators
Charging the Microphone
Features
Contents
- Built-in microphone
- Built-in speaker
- LEDs indicator
- Built-in Lithium rechargeable baery
- TF/micro SD card slot
- Micro-USB charging cable
- Wireless Microphone
- Charging Cable
- 1 Year Warranty
- User Manual
- To charge the microphone, aach the small end of the micro USB
cable to the USB charging port on the underside of the microphone.
Aach the large end to the USB port on a computer, USB cha
rging
device, or a 5V USB adaptor.
- The RED light will be ON when charging, The RED light will be OFF when Full
1. Long press the Power buon. A tone will be heard and the LED indicator
will flash BLUE.
2. Set your mobile device to search for Bluetooth devices. When your
mobile device nds the microp
hone, select M
ic303 from the list of found
devices.
3. Aer a successful pairing, a tone will be heard and the LED indicator will
turn s
olid BLUE.
Note: If a previously paired device is in range when the microphone is turned
on, the microphone will connect to it automacally.
O
n an IOS or Android Device
Go to SETTING>BLUETOOTH
(Make sure Bluetooth is turned ON)
Pairing the Microphone
Mic303
Mic303
Using the Microphone
Power on/o and change mode
Long press the Power button for 2-3 seconds to turn the microphone ON.
Long press the P
ower button for 2-3 seconds again to turn the microphone OFF.
Press to change mode between TF, USB ,line in, Bluetooth mode
Adjusng Volume
Raise the MIC Vol slider to increase microphone volume. Lower the slider to decrease.
Raise the M
usic Vol slider to increase speaker volume. Lower the slider to decrease.
Adjusng REMIX
Raise the REMIX slider to increase REMIX level from the microphone.
Lower the slider to decrease.
Playing Music
To enjoy music wirelessly on your microphone, make sure you are paired to a
Bluetooth-enabled device. Once paired, you can control media playback and volume
adjustment with the controls on your paired device.
Support TF and SD Card, support WAV. MP3;Max expansion: 32GB /Bluetooth
Support Micro-USB line in, Not include 3.5mm cable
Input: DC5V, 500mA
Speaker specicaons: φ45mm, 5W
Bluetooth Version:
V4
.2
Wireless Freq: 2404-2480MHz
Dimensions: 255*78mm
Weight: 300g
Distoron: <1%
Baery Capacity: 1200mAh
Material: ABS
Charging Time: 5 hours
Playing Time: around 8-9 hours
Transmission Range: ap
prox. 10m
Specicaon
Magic Sound
Quickly Press ONCE REC buon to eliminate the original song
Quickly Press ONCE Again to turn on the original song.
Hold on 2 seconds the REC buon to change the Magic sound
total have 5 magic sounds can be choose.
FCC Statement
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the following
measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
Caution: Any changes or modifications to this device not explicitly approved by
manufacturer could void your authority to operate this equipment.
This device complies with part 15 of the FCC Rules. Operation is subject to the following
two conditions: (1) This device may not cause harmful interference, and (2) this device
must accept any interference received, including interference that may cause undesired
operation.
RF Exposure Information
The device has been evaluated to meet general RF exposure requirement. The device can
be used in portable exposure condition without restriction.

Summary of content (1 pages)