Installation Guide

ManualsBrandsShenzhen LINGDU Auto Electronics ManualsAutomotiveCAR DVR

Thank you very much for purchasing our car dash cams.

Ł.Product structure pictures

1.USB 2.Reset hole 3.Auxiliary key 4. Power 5. TF card slot 6.HD display 7.MIC

8.Front cam 9.Speaker 10.AV interface

Button function description:

Power on/off

In the power off state, press and hold the power button for 3 seconds to turn on the

power of the machine.

In the power on state, press and hold the power button for 3 seconds to

automatically save the recording files and turn off the machine.

Reset hole function description

The reset hole is on the back of the machine, if crash happens, please press the

reset hole and reconnect the power to restore files normal.

łProduct installation guide:

1.Turn off the car engine

2.Insert the TF card and SIM card into the card slot of dash cam

ǏAttentionǐPlease use high-speed SD card (Class10 or above, capacity is not less

than 8GB, max to 64GB, and to format the SD card with the machine or PC before

using)

Summary of content (8 pages)

PAGE 1
Thank you very much for purchasing our car dash cams. Ł.Product structure pictures 1.USB 2.Reset hole 3.Auxiliary key 4. Power 5. TF card slot 6.HD display 7.MIC 8.Front cam 9.Speaker 10.AV interface Button function description: Power on/off In the power off state, press and hold the power button for 3 seconds to turn on the power of the machine. In the power on state, press and hold the power button for 3 seconds to automatically save the recording files and turn off the machine. 2.
PAGE 2
3.Fix the dash cam to the rear mirror of the car. 4. Insert the car charger into the car cigarette lighter, and please use the standard 1.5A car charger. 5.Install the rear camera on the rear of the vehicle and pay attention to the direction of the camera when installing. Pave the cable alongside the roof of the vehicle.
PAGE 3
cameras and the rear view display are normal. 4.When the machine is in use, it is forbidden and dangerous to pull and insert the rear camera plug, GPS antenna and SD card, which will cause the recorded video files to be damaged and the machine to be abnormal or damaged. 5.If you need to download the recording videos and images, press SD card directly when the car is turned off. Then insert the SD card into the machine again when the vehicle is turned off. 6.
PAGE 4
Ņ.Product specification Sensor CMOS sensor Lens HD Lens LCD 3 inch OLED display MIC/Speaker Built-in Photo JPG format Video AVI format Audio Built-in microphone/speaker(AAC, MP3) storage SD card (max to 64G) Flash Electronic shutter Car charger 5V/1.5A Working -10ć-50ć˄suggested˅ temperature Working 10%-70%RH humidity Battery 400mAh 3.7V Note: Product parameters may be changed due to product upgrades, updates, etc., subject to the actual products. ņ.
PAGE 5
during the driving process, which will cause the file to be locked. The locked file cannot be overwritten and if there are too many locked files accumulate, the SD card will be full and stop loop recording. ĸ: Power on/off automatically: Please check if the parking mode is turned on. If so, the machine will automatically turn on and record when it detects a collision or a shaking, and automatically shut down after the recording time is due (depending on the recording time setting).
PAGE 6
2.Please check whether the machine is low battery, if so, the above problems will happen. Because of the interference of some car models’ rear lamp voltage pulse signal (German car, American car, Toyota, etc.), there are problems like black screen, screen mess, etc during reversing.
PAGE 7
1.Pulling out the SD card during recording will cause the last video file to be damaged or lost . 2.Abnormal electrical blackout during recording will cause the last video to be damaged or lost. 3.Suffering from devastating collisions during recording will cause video files to be damaged or lost. 4.A large collision occurred during the recording will cause the SD card to be loose at the time, so that the video files will be damage at the time. 5.The videos recorded by the dash cam are only for reference.
PAGE 8
turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: Reorient or relocate the receiving antenna. Increase the separation between the equipment and receiver. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. Consult the dealer or an experienced radio/TV technician for help. The device should be keep 20cm away from people.