Installation Guide

3.Fix the dash cam to the rear mirror of the car.
4.
Insert the car charger into the car cigarette lighter, and please use the standard
1.5A car charger.
5.Install the rear camera on the rear of the vehicle and pay attention to the
direction of the camera when installing. Pave the cable alongside the roof of the
vehicle. After the installation is completed, put the rear plug into the rear camera
interface of the dash cam, and connect the red reverse cable of the rear camera to
the positive pole of the reverse lamp.
6. Connect the dash cam USB interface to the car charger with a charging
extension cable.
ǏAttentionǐPave the cable alongside the edge of windshield.
7. Adjust the lens position to ensure that the lens are level with the ground.
8. Start the engine and check whether the machine is installed correctly.
Suggest to install the machine on the position of original rear mirror of the car.
(picture is just for reference)
The suggested position to get power supply.
The suggested route to pave the cable.
The picture shows you how to pave the rear cam cable---fix machine on A and fix
rear cam on B or C based on actual situation.
Ń.Product installation and use precautions
1.Before installation, please check the accessories carefully to ensure that the
products and accessories are correct and complete, and then start the installation.
2.During installation, be sure not to insert the car key into the power supply, and
do not insert or pull out any machine accessories in the status of Power-on,
including: rear camera, SIM card, SD card. These actions should be completed
when power is turned off.
3.When the car key is plugged into the vehicle, the dash cam will automatically
turn on. Please check whether the function of power on/off, the front and rear