Warranty

向上图标
UP
1.Press Once - to scroll up while in any Menu Settings
2.Press Once - switch front and rear camera on Video Mode or recording
3.Press Once - to scroll to previous video files while in Playback Mode
4.Press and hold for 2-Seconds - to turn on WiFi on Video Mode
向下图标
DOWN
1.Press Once - to scroll down while in Any Menu Settings
2.Press Once - to enable/un-enable audio recording when recording
3.Press Once - to scroll to next video files while in Playback Mode
4.Press and hold for 2-Seconds - to lock current video file
INSTALLATION
Insert Micro SD Card
1. Make sure the dash cam is turned OFF.
2. Insert the Micro-SD Card half way in ( GOLD Contacts - Back the Lens Side)
3. Now gently push the card in until it clicks & looks in place.
4. Must use only Brand Name, Class-10, U3 or higher speed Micro-SD Card.
Remove Micro SD Card
-To remove the Micro SD card, gently push its top edge inward until it clicks, and then pops out, then simply pull it out of
the slot.
Front camera installation
1. Stop the engine where there is some light and in a safe place, and then remove the key.
2. Make sure to clean your windshield from the dust particles and an evaporated grease from the dashboard surface.
3. Attach the Static Clings Sticker (it will leave no residue when removal is required) to the windshield. Peel off the
protective film from the double-sided tape and attach the front camera to the Static clings sticker.
4. Insert the Micro SD card into the Micro SD slot of the dash cam. (Note:please use an A-Brand high-speed Micro SD card,
class 10 or above)
5. Plug USB charger into your vehicle's cigarette lighter socket. Run the cable along your vehicles console and windscreen
and plug it into the camera port marked with the USB icon.
MOST IMPORTANT about Micro-SD Card
1. Do not remove or insert Micro-SD card when the camera is powered on which may damage the memory
card.
2. You MUST Format the Micro-SD card in camera for the first time using.