Warranty

6. Use the cable clip to organize and hide the power cord so that it doesn't interfere with the driver's vision.
Rear camera installation
1. The rear camera equipped with a 6-meter cable is to connect to the dash-cam via AV-IN port. Please check if the
provided cable is long enough to reach the rear cam in your car.
2. Install the rear camera near the license plate. Feed the camera wire through to the interior of the vehicle either by
drilling a new hole; or using the existing hole for the number plate light if possible. The two included screws and double
sided tape will hold the camera in place.
3. To use the reversing function, connect the red cable of rear camera extension cable to the anode of the car reversing
lamp by using a test light or multimeter to determine which wire is anode.
4. Once all of the plugs are connected and power connections are made. Switch on the ignition. Shift the gear into reverse,
and if all is wired correctly; the rear camer image will appear in your dashcam.
Note
① Please clean the position to ensure the adhesive quality before install the rear camera.
② Please fasten the screws to adjust the desired rear camera view angle.
GET STARTED
Power On/Off
Option 1: Start the engine to automatically power on the Dash Camera;stop the engine to automatically power it off.
Option 2: Press power button once to turn on device; Press and hold power button for 3 seconds to turn off device.
SETTING TIMEZONE AND DATE/TIME
①Set the UTC/GMT value first.