User's Manual

USER MANUAL

1. ON-OFF( Power ON/OFF,Automatically get into pairing status)

2. LED light

a. Blue lights flashing slowly after power is turned on, Red and blue

alternately flash after pairing,slow flash recovery after paring is successful

b. The battery indicator: red lights flash at low battery status,red lights keep

always bright when charging. Red lights off after finishing charging.

3. Single click the button to answer and hang up a income call,double-click

the button to dial the last number dialed,Press to refuse a income call.

4. Single click for last song(rewind), press for volume up

5. Single click for next song(fast forward), press for volume down

6. Single click for Pause/Play

7. Micro 5 pin USB port for power charging

8. Aux in

9. Microphone

FCC warning statement

This equipment has been tested and found to comply with the limits for a

Class B digital device, pursuant to part 15 of the FCC Rules. These limits

are designed to provide reasonable protection against harmful

interference in a residential installation. This equipment generates, uses

and can radiate radio frequency energy and, if not installed and used in

accordance with the instructions, may cause harmful interference to

radio communications. However, there is no guarantee that interference

will not occur in a particular installation. If this equipment does cause

harmful interference to radio or television reception, which can be

determined by turning the equipment off and on, the user is encouraged

PAGE 1
USER MANUAL 1. ON-OFF( Power ON/OFF,Automatically get into pairing status) 2. LED light a. Blue lights flashing slowly after power is turned on, Red and blue alternately flash after pairing,slow flash recovery after paring is successful b. The battery indicator: red lights flash at low battery status,red lights keep always bright when charging. Red lights off after finishing charging. 3.
PAGE 2
to try to correct the interference by one or more of the following measures: • Reorient or relocate the receiving antenna. • Increase the separation between the equipment and receiver. • Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. • Consult the dealer or an experienced radio/TV technician for help. Caution: Any changes or modifications to this device not explicitly approved by manufacturer could void your authority to operate this equipment.