User's Manual

HP-WH900 transmitter user manual

The HP-WH900 transmitter adopts the crystal oscillation amplifier, low

consume current.

Operation manual

Transmitter sketch map

1. LED: Power ON/OFF indictor

2. ON: Power ON

3. OFF: Power OFF

4. ANTENNA: Radiation antenna

5. AUDIO: audio input

6. DC IN: AC/DC adopter input jack

7. BATTERY DOOR: 6F22 battery door

How to use

1. Open the transmitter’s bottom door, put in the 6F22 battery, or put the

PAGE 1
HP-WH900 transmitter user manual The HP-WH900 transmitter adopts the crystal oscillation amplifier, low consume current. Operation manual Transmitter sketch map 1. LED: Power ON/OFF indictor 2. ON: Power ON 3. OFF: Power OFF 4. ANTENNA: Radiation antenna 5. AUDIO: audio input 6. DC IN: AC/DC adopter input jack 7. BATTERY DOOR: 6F22 battery door How to use 1.
PAGE 2
AC//DC adopter (120V/12V, 200mA) jack into DC input, put you audio source into Audio input jack, pull up the ANTENNA. Press the ON/OFF switch, the LED light, then working on. 2. You can turn the transmitter’s audio input volume, acquire a good listen effect. 3. If the LED light darkle, its need to recharge the battery. Warning Changes or modifications to this unit not expressly approved by the party responsible for compliance will void the user's authority to operate the equipment.
PAGE 3
--Reorient or relocate the receiving antenna. --Increase the separation between the equipment and receiver. --Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. --Consult the dealer or an experienced radio/TV technician for help. The equipment complies with FCC radiation exposure limit set forth for uncontrolled environment.