User's Manual

PS2/PS3-V6RFC 新产品 IC: MAW0010+ 5201M052AB-D
 Relocate foot pedals to RY axis
(1) To set up the function
1. Press the SELECT+START buttons for 3 seconds, the LED is on
2. Press the foot pedal, the green LED turns off and the setting comes into effect.
(2) To clean up the function
1. Press the SELECT+ STRAT buttons for 3 seconds, the green LED is on
2. Double press the foot pedal which has been set as RY axis, the green LED is off
and the setting has been cleaned up.
 Sensitivity adjustment
1、Press and hold SELECT+START for 3seconds，the LED is on;
2、Press SELECT button, showing current sensitivity;
3、Press SELECT button again to select mode as following:
Middle (G-LED illuminates) highest (G-LED flash quickly) lowest (G-LED flash slowly)
4、Press the UP on the D-pad to exit adjustment
 Low Power Consumption (sleep mode)
In order to save batteries power and prolong batteries life, the wireless wheel
features a sleep mode if it has not been used for a period of time. There are 2
ways getting into sleeping mode:
1. If the Steering Wheel is not connected with the console for over 4
minute, the Steering Wheel will turn OFF automatically,
2. If the Steering Wheel is connected to the console and not used for
over 3 minutes it will enter a Sleep Mode
To Exit the Sleep Mode, Press Start button on the Steering Wheel the LED will
then turn on.