User's Guide

Robustel C9200 User Guide
RT_UG_C9200_v.1.0.1 for NA 27 Nov. 2019 4/27
Protecting Your 4G IoT Wireless Gateway
To ensure error-free usage, please install and operate your 4G IoT Wireless Gateway with care. Do remember the
following:
 Do not expose the 4G IoT Wireless Gateway to extreme conditions such as high humidity / rain, high
temperature, direct sunlight, caustic / harsh chemicals, dust, or water.
 Do not try to disassemble or modify the 4G IoT Wireless Gateway. There is no user serviceable part inside and
the warranty would be void.
 Do not drop, hit or shake the 4G IoT Wireless Gateway. Do not use the gateway under extreme vibrating
conditions.
 Do not pull the antenna or power supply cable. Attach/detach by holding the connector.
 Connect the 4G IoT Wireless Gateway only according to the instruction manual. Failure to do it will void the
warranty.
 In case of problem, please contact authorized distributor.
Federal Communication Commission Interference Statement
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This
device may not cause harmful interference, and (2) this device must accept any interference received, including
interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning
the equipment off and on, the user is encouraged to try to correct the interference by one of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that
to which is the receiver is connected
Consult the dealer or an experienced radio/TV technician for help.
FCC Caution:
Any changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to
operate this equipment
This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.
Radiation Exposure Statement:
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment
should be installed and operated with minimum distance 20cm between the radiator & your body.