Technical Specs

FCC STATEMENT :
This device complies with Part
conditions:
15 of the FCC Rules. Operation is subject to the following two
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that may
cause undesired operation.
Warning:
compliance could void the user's authority to operate the equipment.
Changes or modifications not expressly approved by the party responsible for
NOTE: This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Par
reasonable protection against harmful interference in a residential installation. This equipment
generates uses and can radiate radio frequency energy and, if not installed and used in accordance
with the instructions, may cause harmful interference to radio communications. However, there is
no guarantee that interference will not occur in aparticular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the interference by one or more of
the following measures:
t 15 of the FCC Rules. These limits are designed to provide
Reorient or relocate the receiving an
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
Consult the dealer or an experienced radio/TV technician for help.
tenna.
FCC Radiation Exposure Statement:
This equipment complies with F
environment.
This equipment should be installed and operated with minimum distance 20cm between the
radiator & your body.
CC radiation exposure limits set forth for an uncontrolled
OUTDOOR POWER PACK
USER 'S MANUAL
Name:Battery Pack
Capacity:3.2V/96000mAh/307.2Wh
Battery pack capacity:12.8V /24000mAh/307.2Wh
INPUT:
DC Input:18-24V/4A(Max) Max Solar charging: 80W
USB-C Input:DC5V/3A 9V/3A 12V/3A 15V/3A 20V/3A
OUTPUT:
Cigare Lighter Socket output:12V / 15A(max)
USB 1&2 Output: 5V/3A 9V/2A 12V/1.5A
USB-C Output:DC5V/3A 9V/3A 12V/3A 15V/3A 20V/3A
DC Output:12V/5A 16.5V/4A 20V/3.5A 24V/3.5A
Wireless:10W
Measure:225.8*165*76mm
N.W:3043.4g
Technical Specifications
Thanks for choosing our product, Please read the manual carefully
before use
Package Contents
1x Power Pack
1x20V/2A Adapter
1xC-C Cable
1xManual
1x8+1 DC Laptop Connector
1xHandly bag (Option)
1xCPAP Cable (4PCS) Option
Use the DC③ or USB C⑤ input port to charge, but can't work together to recharge
1. Plug the adapter`s cable into the DC③/USB C⑤ input port of the battery pack. Please use supplied
adapter or PD charger (Power Above 60W is recommended).
2. Connect the adapter to AC 100V-240V
3. Charging will begin automatically
4. Recharging time: It will take about 10 hours to fully charge the battery pack with supplied adapter,
about 6 hours with branded PD charger (60W or above).
Solar panel charging time will vary from the power of solar panel and light intensity, it will support up to
80W recharging.
Click the power button to turn on the wireless charging function.
The digital display screen shows the power bank battery level:
One grid means 25% battery Power,
two grid means 50% batery power level,
three grid means 75%,
and four grid means 100% battery power level (as shown in the picture).
1. USB1 and USB2 are suitable for charging mobile phones, tablet and other digital devices.
2. USB C⑤ is suitable for charging most laptops and devices with USB C charging function.
3.The Power Bank can automatically charge the device. If it cannot be charged, please check the connection
cable and press the power button①.
1. When charging your DC devices, you need select the correct voltage and connector first.
2. Long press the voltage set button② for 3 seconds, the select-able voltage value(12V, 16.5V, 20V, 24V. ) on the
LED Display⑧ will flash and stay on each voltage for 5 seconds. Short press the voltage set button② to jump
among all select-able values till you find the right one for your devices. After the voltage value on the LED
Display⑧ stops flashing, the DC port④ can output the voltage.
3. Connect the DC connector to the device and strar charging the devices
4. If unplug the DC port④ devices,The power bank will continue to work (light on) for 2 hours,after 2 hours the
power bank will automatically turn off. Or after removing the device from the DC port④, manually long press 5
seconds the Power button ① to turn off the DC output function
Recharge Power Bank
LED Display
1. Pass-Through charging: DC③ input and DC port④ output can be used at the same time
2. USB- C port⑤ and DC port④.These two ports will not automatically turn off after charging. The
powerbank will turn off automatically after unplugging the device for two hours. Or you can manually
turn off the power by holding the switch button ① for more than 5 seconds
3. If using a power inverter with your power pack, ensure it is no more than a maximum 150w.
4. To protect the battery cycle life, Please unplug the charging cable after it is fully charged
when using the AC adapter or a USB- C charger
5.Do not store in extreme heat or coldness, near anything flammable or explosive and keep it
away from damp areas.
6. Run a full charge / discharge cycle at least once every four months to avoid shortening the life
span of the internal battery.
7. If long term storage is likely to occur between uses, we recommend atoring power at
approximately 50% full.
8. Although the 12V socket is capable of pass through charging, avoid charging and discharging
the Power pack at the same time as this may reduce the battery's life span.
9. Please note the cigarette lighter output voltage range is 12V-14V.
10. When supply power for different devices. A further 10% - 20% is lost by the.device being
charged and the charging cable used. Always use the original.cable supplied with the device
being charged for optimum results.
11 . Using your Power pack in temperatures below 0C or above 40C is highly unadvisable and will
likely cause irreparable damage to the internal battery.
Q1. Can I charge four devices at the same time?
A1. Yes, but the total power does not exceed 300W. It is recommended not to connect USBC or DC
when the 12V cigarette lighter port is working at full load.
Q2. What should we do if the power bank can't recharge?
A2. Please check the charging adapter is connected correctly and the 100v-240v AC charging
is enabled, if the problem still exists, please contact the supplier for more professional advices.
Q3. What shold we do if the power supply cannot charge other devices?
A3. Please Check the charging line is inserted in the correct port, or checkwhether the
output of this power supply is compatible with the voltage ofelectronic devices. Refer to
your device's manual, product label, or adapter
MADE IN CHINA
Usage Notes
FAQ
Warranty
We provide customer with a comprehensive warranty of 12 months from the date of purchase.
12V Cigar lighter socket output
Power to other DC input devices
Emergency warning light、LED Light
Charge your digital devices
Identification of parts
Wireless charging
Warning light: .Long press the power button to turn on the orange warning light, and long press again
to turn off the orange warning light.
LED light: Double click the power button to turn on the white LED light, Then double click toturn off the LED light
Click the power button to turn on the wireless function, Max 10W wireless charging.
1. 12V devices Supported: Car refrigerator/inflator pump,UAC battery/outdoor tent
light/ Camp light/fishing light/hunting light/fan and other devices under 150W.
2. Plug the devices into 12V cigar lighter socket.
3. The Socket will automatically power the connected device.
4. To Turn off the deviecs & unplug it from the power pack.
USB1 Output
DC Output
USB2 Output
USB C Input/Output
DC
IN
USB C
IN/ OUT
OUT
USB 2
USB 1
OUT
DC
OUT
12V /15A
O
U
T
12V /15
A
OUT
DC Input(Can't work together
with USB C⑤ port)
Power Button
LED Light , Emergency Warning Light
Wireless Charging Area
LED Display
DC Out Voltage Set Button
12V Cigar Lighter
Output Socket
12v Cigar Lighter
Output Socket
2
4
7
8
9
1
3
5
6
6
7
10
OUT
%
V
DC
IN
USB C
IN/OU T
OUT
USB2
USB1
OUT
DC
OUT
12V /15A
OUT
12V /15A
OUT
Macbook
For CPAP
USB-C devices Out: Such as
Laptop/ Phones. etc
For 12V Car set devices:
Such as Car fridge.etc
For Wireless devices, Such as:
Mobile Phone/Wireless headset.etc
So ar chargel
OUT
%
V
24V OUT
For CPAP
12V OUT
Macbook
For DC12-24V devices:
Such as DC laptops
Wall charge
Wall Charger Input
OUT
%
V
OUT
%
V
OUT
%
V
Car charger