Users Manual Part 1

6 Customizing the Analyzer Software
Operator’s Manual 6 - 9
6.3.4 Para. Setup (Administrators)
Parameter unit setup
Administrators may set up unit systems and parameter units.
1. Tap “Menu > Setup > Para. Setup > Parameter Unit Setup” to enter the “Parameter Unit
Setup” screen.
2. (Optional) When necessary, select the unit system from the “Unit System:” pull-down list.
3. Tap the “Unit” column of the parameter for which you want to change the unit.
The available units for the parameter displays on the right side of the screen.
4. Check the desired unit for the parameter in the “Unit System:” area.
The parameter unit refreshes.
NOTE:
• Users at operator's level can only review the unit system and the parameter units.
•Tap “Default” to restore the default units for all parameters.
Ref. range setup
Users at administrator's level may select and customize reference ranges and reference groups.
1. Tap “Menu > Setup > Ref. Range Setup” to enter the “Ref. Range Setup” screen.
2. Add a new reference group, edit or delete reference groups, or set default groups as needed.
Enable fluorescent
reagent detect sensor
When “Enable fluorescent reagent
detect sensor” is checked, if the
fluorescent reagents are not sufficient, the
analyzer will send an alarm.
/
Monitor reagent
expiration date
When “Monitor reagent expiration
date” is checked, if the reagents expire,
the analyzer will send an alarm.
/
Flags Select from the pull down list to define the
suspect, high and low flags (default: “R”
for suspect, “H” for high and “L” for low).
Suspect: R, r
High: H, h
Low: L, l
Alarm Volume
Choose a proper alarm volume Low, Medium, High, Max
Item Description